Search results

Its been fun and real, but sadly I'm leaving the Supra scene for a while. 2008 Volvo C30 polestar tune took the place of my Supra. I have to focus on school and won't have time to repair this jap delight. I had this car for 10 years it was my first car and was a part of me and greatly saddens...

Hello guys Kind of in a bit of a sticky situation. The rear camber bolt what's the specs on it? I'm installing the rear camber battle version arms and the tech said he has to cut the bolt off but they don't have any replacements. Is this something I can get at home Depot. I don't need...

Not sure if this has been covered. couldn't find anything on this subject. In regards to the brake master cylinder are they interchangeable with the abs and no abs units? I need to replace my brake master cylinder. My mk3 does have ABS, and I was just wondering if I can replace it with a non-abs...

I need your guys advise the connector for the oem oil pressure sending unit broke into a million piece what do you guys used to replace it ? i noticed that some tundras have the same connector

Quick question my center console bezel where the radio and empty tray goes. The radio doesn't sit flush inside the bezel..I read somewhere on here that ppl use aftermarket gauges they use abs plastic? To mount gauges and other stuff in the center console bezel. Is this true or did I understand...

okay I know for sure i have a usdm 7mgte but it came with the egr blocked off so i did the right thing and ordered a jdm ecu that correctly matches my harness/ecu. I know that the jdm engine doesn't have egr,bvsv, and charcoal canister. now that i have the jdm ecu what do i do with the other...

So i came across this video and take a look on Amazon and.....what do you guys think? or is this another crap HID setup...

OKay im a little pissed off right now ..i removed the harmonic balancer (starter trick) i took off the woodruff key i wanna replace the front seal but how do i take off the crankshaft pulley??? some one please help me! Its on a 7mgte

Is Driftmotion the only place that sells the 7m OEM fan shroud(dual aux fans)??

Hello everyone! ill be quick, I need a new muffler for my 7mgte. Just tired of my old no name brand, rattleing muffler from a cheap exhaust shop. Was wondering whats the best bang for my buck which is under $120.00. My current setup is a full 3in exhaust stainless steel no catr or...

Soo.. im lost here i have a 1988 Toyota Supra with a 7mgte/R154 im trying to put the pieces together after the previous owner suck major balls... OKay NOw..i have the regular clutch fan right... Next to that i have 2 small radiator Fans..from what i learned the connectors are behind the...

i was cruiseing to work at around 50mph when the car just shut off on me...i was able to steer into a gas station ...i quickly pulled the codes 14,24 but whats funny when i try and turn the car on i notice the rpm needle doesnt move at all...could it be the cps wiring??? thanks for the help...

Hey fellas, hopefully someone here can school me on this subject this morning om my way to work i notice my check engine light come on and the car started to idle under 500rpm it drove fine but the rpms were to low and my vaccum gauge wasnt reading correct i quickly pulled over and check my...

i have a 88t with the 7m it came without the a/c fan that should be located in front of the a/c condenser. The sensor for that used be located on the thermostat housing my question is do 7m share that same sensor/Fan with a camry or celica ?i see alot of them at the junkyard i was just...

i did some research on this subject i just wanted to make sure im correct before i proceed with this j-tub mod I do have a walbro 255 fuel pump but everything else about the fuel system is oem Now the question by doing the jtub mod is it safe to go thru with it even tho i dont have...

i had to change the water neck gasket and that 90* hose under it. It seemed like the CPS had to come out in oder to move the Water neck outa the way. i markED the spot where the bolt goes on the engine so i know where to put when i insert the cps.. After i installed everything..the car didnt...

research had lead me to believe that 7mgte comes from facory running:3d_frown: rich. My plan is tune the car without 550s and lex afm is that even possible? I have 3in exhaust from the turbo to muffler, intake, Greddy BOV, Aftermarket Interooler with 2.5in ic pipes, walbro fuel pump. so as it...

i have seen and read about ground kits on many cars but never seen one on a 7mgte motor or IJz motor does anybody have any pictures of there ground kits??

On a hot day in south florida! why would my iscv connector brake in into millions of pieces? becuase i have bad luck!! so now i gotta cut/splice the 6 wires for the connector. but of course i dont know where the 6 multi color wires go on the iscv. Can anybody piont me in the right direction...

what is this wire for exactly?? i have one on my alternator but the wire is all cracked and messed up ... wtf should i do about this wire?? this wire is located on the back of the alternator on the outside hopefully this picture works. Thanxz for the help