Search results

hey, im wanting to connect a vf meter and was wondering if anyone knows where to connect it to. check connector has vf1 and vf2, but ECU pinout only has VF (check connector) im wanting to connect it to the ecu, if that possible, its for a 1991 wiring. anyone know...

hey, i have read the boost leak tester and theres some things that i dont get first is- i know you put it over the inlet of the turbo, but wont that go out the exhaust/manifold area? second-will this test vacuum hoses as well? third- this only tests intercooler pipes and intercooler itself...

hey, just looking at supra pictures and i found one that seems very very interesting, especially the stance. if anyone knows whos it is, please reply, thanks sorry if this is the wrong place to start a new thread

hey, just a question. i dont really see what people set their alignment for the track. i have seen some very aggressive alignment setups, but i just want a mild or something that can be used for the streets as well. also if you lowered the car, how should you align it back to spec? or should...

hey, if anyone knows this let me know, currently if im at partial throttle (25%-35% ect) my car will run rich to the point where its 10:1.idle and cruise are fine where its reading 14.7. i read that open loop starts at 69% throttle. could this be caused by my fpr? i dont have a afpr yet as i...

hey so basically i have a problem, not sure what it is. so when the car is cold or sat for at least 2-3 hours. when i start it up it idles and my a/f ratio is fine 14.7 then it goes rich because of the cold start injector (about 5degrees in canada). durigng this time when i drive it its...

hey, recently after working on the ecu..my battery/tail light/handbrake light is on. stupid me i forgot to disconnect the battery while depinning the 26 grey connector on the ecu side. i have double checked that every pin iv disconnected it dosent run to the alternator wires ect. first...

hey, im, trying to do my wiring harness and its all depinned from the 26 connector one (26pin grey plug) can anyone take a picture of both sides of the connector to show me the colors ect? thanks P.S i did take a look at this...

hey, apparently someguy before me who owned the car cut the ne wire to short, causing a code for me, how do i depin one wire from the ecu connector? i already opened the flap but it wont come out or push in. any tips.advice? thanks

hey, just a question, im starting to tune my car (just a bit before i bring it to the dyno) so i read the a/f ratio article here: http://www.supramania.com/forums/showthread.php?14358-A-F-Ratio-Tuning so does that mean when im cruising or driving normal it always has to be at 14.7? i know...

soo, today i decided to start my car and run it, i just finished the head gasket, so i decided to just for around the block. so when i do go around the block, i park back on the driveway, and apparently 5 min later a cop comes by, and eyes my car, i kinda had a feeling that the cop either...

hey, im trying to take off my rear hub and currently while taking off the ebrake cable, it goes through the dust cover. does anyone know how to take it out? mines all rusted near it and it dosent seem like there's a way to take it out. has anyone every took this ebrake cable out of the dust...

hey, im currently installing my Energy bushings and i just want to know if the rear No1 and No2 suspension arm bolts are easy to take off. i have heard of the camber bolts seizing (front lca and rear camber) im currently using a c-clamp to take out my bushings, iv already took out the front...

hi, i recently just did my headgasket, i marked down the notches on the cam pulleys to the timing belt, after i reinstall everything i tried to install the timing belt. i even made sure the intake side and in between the intake and exhaust cam pulleys were tight. after i install everything...

hey, i did a search on supramania and the guides, everyone says to put it at 10btdc but i had my car set at 0 because thats what tsrm says, should i just leave it at 0 or change it to 10btdc? any input would be nice. thanks

hey, im halfway there to take out my head to put a headgasket on, and was wondering while i have the head out, is it possible to change the driver side motor mount by just lifting it up using a jack and install it in? i dont see why wont it work, but if it dosent i just dont want to go through...

hi, i was just wondering if these wires are shielded, im trying to repair my wires, or is this just a regular wire that i can splice together? Thanks

hey, just wondering, does the rear toyota supra emblem have a specific colour to it? my turbo emblem is white, and the "supra logo" is painted over with the body colour(which is burgundy), so i was wondering if theres a specific white colour code for it. i want to paint it back to white. do...

does anyone know the part number for a turbo supra? i cant find it nor does it have a part number so does anyone have a part number i can get at the dealer or maybe a interchangable one form a different toyota car? Thanks

ok, so i sold my stock wheel long time ago, i got a momo steering wheel(the ones on ttr's japan supras) so the thing is i came install my steering wheel hub all the way in, is it hard to press in? and how do you find the center of it? i remember i did an alignment and my steering wheel was at...