Search results

Hey all, Its been a while since Ive been active on the forums and I know the Knowlwdge base is very well verse on these cars so here is my problem 7MGTE MKIV TT Fuel Pump Stock FPR Basic setup.... For a few weeks now Ive been driving the car with not knowing a Stock FPR from a...

ok all, I need some assistance and Im sure you gurus will know what I should do. While I was re-installing my 7MGTE back into my car I was at the last few things to connect. So when I was at the starter connection I connected the cable and tightened the 10 or 12mm bolt. I then connected the...

Ok so my current supra build did 663rwhp on the Dyno and with my last pull blew a few Ringlands on my stock Pistons. Always wanted to see how far I can push them and I found out. So I bought a set of Weisco pistons which are Higher compression than stock Pistons. So I have 2 Questions here. 1...

Hey you all. I just have a Quick Question. I have 2 cold start injectors sitting here and both of them came from a 7MGTE but they are different Lengths. One is just skinny with the spray Nossle at the end and the other one is about a inch shorter and has a piece on the end of it with the...

Hey all, Its been a minute since I was on here and its good to see you all still doing well. So here is my Question to all of you as this is going into a current build. 1. Have a 7MGTE that has been honed out one before but has been pushed pretty hard and starting to go through a good amount...

Ok all, Im at my end with this Issue. Everything that I have done so far has failed to correct this. Im going to list a few setting in hope that someone can lead me in the correct direction. Maft Pro with correct Software. Mainscale set to -25 AF Voltage is reading 2.7v to 3.0v at Idle which...

I converted Everything out from a 88 to a 89 Specific Wiring harness. I bought a 89 ECU from a Friend of mine in california not knowing that the ECU were a little different ie... Code 71. I did the Resister mod as everyone recommended and now Im getting this Beep/Buzz Every 2 or 3 seconds from...

Strange code and never ran into this one before. Code 71.... EGR Malfunction Problem: Im not running a EGR setup. I have a Ron FFIM. So why am I throwing this code, Just Popped up this morning, Never had this Problem before. Anyone got any Ideas on what I can do to get the CEL to go out...

Howdy you all, Im going to put up a youtube Video of my car starting for the first time. Each and Every morning its the same thing. Ignore the Open Exhaust as Im redoing the Exhaust System. Just a little list of Mods. T76 Turbo Evo 560cc Injectors MAFT Pro Stock Cams Ron FFIM...

Its been quite a while since I have had this harness in the car and Im hoping that I can get some Direction on that I can do to fix this problem. I start the car up in the morning and using my MAFT Pro I know that Im not suppose to get a VF signal for atleast 30-45 Seconds and during that time...

Hey all..... Its been a while since I posted anything and Im at the end of the Straw on this one. Could use a little Insight here as to this Problem. Basic Mods. Ron R FFIM Q45 Throttle Body and TPS GT4067R Turbo MAFT Pro etc etc etc Start car and Watch MAFT Pro TPS voltage, Once...

Hey you all. Im having turbo Surge problems and Ive done pretty much everything that I can think of so any recommendation would be great.... Setup.. GT4067r DBB Turbo 3 1/2" Piping from IC to Q45 throttle Body 2 1/2" from turbo to Intercooler HKS SSQV BOV. Problem: Doesnt matter...

Hey all, I know this all sounds strange and Im puzzled so I figured I would ask here. Im stalled another wiring harness in my Supra and everything is wired in as usual. Start the car up and she Purrs like a Kitten. Look at my MAFT Pro TPS voltage and its reading .38 to .40v which is where...

MAFT Pro running Speed Density When I start the car up and Im watching the AUX-1 signal how long does it take before you should start getting a reading... I do understand that it should read 0.00 for a minute or two until close loop and then start showing something after that. Reason Im...

Good Afternoon, Morning, Evening all Have a Question and Im pretty sure most of you know the Answer. I have a friend that Bought a 7MGTE supra engine and he said that it came with Vemon 660cc Injectors. When he took a Pic of them they were Yellow top Injectors and look Exactly like 295cc...

Ok, I know that this has been covered before and Im sorry that I cant find it using the search function. Currently my setup is going to be ran off wastegate spring only. How do I correctly hook-up the Vaccuum lines so that everything is run correctly. there is a Port on the Side and a...

Stupid Question I know but I want to make sure Im doing this right. Do you measure the compressor wheel blades from tip to tip across for the Enducer and the same for the Exducer. If there is a link already posted sorry for the Duplicate Q. I couldnt find it. Robert

Has anyone ever used these in there setup. I bought 2003 IS300 coils but they sent me a set of 2003 ES300 coils by mistake, It was corrected but was told to keep the ES300s. So can these work with Proper Modification.?

Anyone ever heard of this Turbocharger. I cant seem to find anything online about it so I figured that I would ask here. Seems like a good T4 Based turbo but I would like to find out specifics on it. Any help would be Appreciated. Robert

Ive been looking and looking but maybe not in the correct Place. Just trying to get an Idea on what Style Turbo Manifold you all are running on your 7MGTEs to make power above the 600-700hp mark. Ive seen and Im currently using the SS Autochrome mani but the Wastegate hangs down so far that its...