Search results

  1. M

    Turbo A duct how much are they worth?

    I found two in my MD garage while I am emptying it out. Both are painted dark blue pearl and are the 86-88 versions. They are the real deal I bought back in the 90s. What are they worth? Thanks.
  2. M

    Another code 52 nightmare

    UGHHH.... Here is what I have done New knock sensors Shaef kit with the ground on the upper right hand side of the dash under a 12 MM bolt. Also tried using one of the screws that the ECU mounts too to mount the ground Swapped with 3 different ecus Harness is good going into the plug...
  3. M

    Who can remove speed limiter on a JDM 7MGTE ECU?

    Thank you!
  4. M

    Running 7MGTE Jap ECM with HKS piggybacks

    Since I got rid of EGR years ago and there has been a big debate on the past saying this is bad with a USDM ECU I am getting a JDM 88 ECU. My question is will this create a problem with all of my hks piggybacks?(ie VPC,GCC,Fcon etc..) in terms of combatibility? Thank you
  5. M

    Anyone running a JT62 with BB option?

    Curious how much faster it spools or who has one. Thank you
  6. M

    Nice bottom end stuff?

    After years of abuse my stock 7M let go tonite. Have oil everywhere. I can't complain. 9 years of abuse and 100s of passes I am sure I broke a ring or two tonite at 24 psi and race gas/meth. I will pull and take apart. What pistons and rings are decent for my power level(low 500RWHP)?
  7. M

    7MGTE vs EVO,04 Cobra,WRX,Big block Fbody

    Like most of you I getting really SICK of this damn car at times. Its been by far the most unreliable Toyota I ever owned. But when everything is right its a lot of fun and a real sleeper. My car has a stock 7MGTE bottom end with ported head,honed manifolds,3" down pipe,hks piggybacks...
  8. M

    Does the JDM GTE ecu have a speed limiter?

    Thanks.
  9. M

    Another problem with code 52

    In 8 years of having this car I never had a CEL in this car.... As of 2 months ago I got a CEL on my 88 turbo with a little over 100K on it. Code 11 Cleaned and inspected all grounds. Looked good. Replaced coil pack tray ground. I then got code 52 after clearing it. Sometimes right...
  10. M

    My 88 SCMR2 vs my 88 Supra turbo

    This is my MR2. Ported TB,pulley(14 psi),gruntbox,89 rear swaybar and K&N air fliter. Has run 14.1 on street tires with 1.89 sixty foots. ON the street I can dump it at 4 grand and it moves out. Pic of it launching Have an 88 Turbo hardtop. Ported head,extrude honed manifolds,hks...
  11. M

    Code 11

    My check engine light comes on after about 7 miles of driving even after clearing codes per Super Monitor. The code means at the some point the ecm is losing signal/power. All connectors are tight on the ecm. HKS ad ons(fcon,vps,gcc) the same. Ignition is stock. Car has brand new Toyota plug...
  12. M

    Pulling codes off Super monitor

    I don't have my factory repair manual so whats the procedure for looking up codes? Thank you
  13. M

    Good tuner in MD/DC area? Piggybacks

    Thanks.
  14. M

    Plug wires for 7M-GTE

    Sorry I have been out this game for a while.... What wires do you guys like and where to buy?
Top Bottom