I can only comment on the Toyota system, not any hacked up system with aftermarket noise makers.
If there isn't power to on the small wire when cranking, test output of the starter relay. You could always just swap out the relay with a known good unit to see if the relay has failed, or the...
If you had the steering wheel off, and now the horn doesn't work, then take it apart and have somebody that knows how to install it help you.
Factory radio?
You need to get a meter out and check against the EWD for what is missing.
The ignition switch powers both sides of the starter relay. Your theft deterent provides a ground path for the relay. You can check for B+ on the big wire on the starter, and check the small wire for B+ when your budy...
If you are moving the quench area further from the combustion chamber how is that good?
The tech note above is correct, but I am talking about moving it away from the combustion chamber. He has a 7MGE, not 7MGTE with significantly increased boost pressures.
350cc engine, wow, I didn't know GM was building them so small these days...
As stated several times, buy the gasket after the head and block have been prepared. The machinest tells you how much was removed, then you make the purchased based on that.
I don't think that is the only problem. Funny thing, this was just brought up in another forum....
That gap is where the air and fuel will swirl quickly and mix thoroughly, and it pushes the mixture to the combustion chamber. And guess what, that lowers the threshold for detonation.
If...
14 means the ECU did not recieve a signal indicating the ignitor fired. If the ignitor does not fire, neither will the injector. Pull the EFI fuse for 30 seconds and see if you still have the 14.
You might have a wiring problem, and you are only getting an intermittent signal to start the...
If you can move it by the rod with your hand, then you need to think about the motor, and its power supply.
I don't know if the electrcial and climate control on your car is different.
http://www.cygnusx1.net/Supra/Library/TEWD/MK3/manual.aspx?Section=Main&Page=140
Examine this and...
I put mine in, something I have only done one other time. But to be straight, Mattjk's looks like a better all around package right now. Even with the inferior engine. ;)
Is there anything obstructing the mode vent door? Does it move by hand easily with everything disconnected?
I asked because you indicated it was difficult with everything hooked up correctly.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.