4 inch is too big for a ct.
Use a full 3in from turbo back including elbow.
As for muffler anything you want.
Nur spec is loud and the Apexi n1 is a tad loud but sounds good.
Prolly the glue the used is not working well with the heat.
A lot of the stock panels will start cracking and such. Pretty common after all the years.
Not to sure if you can even get a new panel from Toyota. But you can find them used on here.
Pm Albert or looks for his section.
Any boost controller will do. Cheap mbc's off eBay I would stay away from tho. And generally eBay itself unless its genuine.
Think only 10 wezel wings were made and everyone that has one doesn't want to get rid it. Maybe seen a couple for sale but not often.
Beech sells some braces but it's a bar on each side. Don't know how they perform.
Seen some home made x braces.
If you have a welder wouldn't be hard...
No would need to have the same clearance spec as over shim buckets.
Best best is to go to a junkyard if you can find them and get a lot use the ones you need and sell the rest.
Buddy melted a piston at 17-18psi without 550's.
If your monitoring it you can be somewhat safe but then again your running high fp through 20 year old injectors...
160 degree stat will delay full warm up times keeping the car in cold start enrichment mode.
Use a stock Toyota t stat and use Toyota red with distilled water.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.