Search results

http://www.gtfactory.jp/cms/page.php?9 I know rwdanothony test fitted these coils and likes them a lot. I mainly use my car for dd with occasional spirited driving. Like to do road coarse but no time.

I have zankoku performance coils. Was a group buy long time ago. Had them indie about a year now. Have 16f/12r spring rates. Shocks are on second softest dampening adjustment and it rides really smooth. Maybe a little harsher than eibachs but a lot better through turns. Right in the middle is...

Looks like it has some sort of sandwich plate for the oil filter. Doesn't look stock to me.

How do you know there not machined for a 1jz? They didn't fit? Or did you measure them?

Saw it at Toyota fest couple months ago. Don't really like all the sharp body lines. Look fun to drive tho.

^ says there not installed yet.

Ya it's normal for it to do that unless you do the rewire. Also the sogi short shifter is a love / hate thing. Personally I hate it and don't like the shifter so low.

Looks clean but way to much for a pre89. Maybe for a 92 in perfect condition.

It's only stupid if the previous owner put it in a bad spot. What kind of fuel pump did you put in?

Have you taken it off your old cluster already? The green is labeled. There is screw holes and light bulb holes. Google images. http://imageshack.us/photo/my-images/205/dscn2966copyru2.jpg/ http://imageshack.us/photo/my-images/853/dscn7135l.jpg/

What year is your car and what year is the cluster?

Make sure non of the coil packs aren't cracked. Not too common on the 7m but it does happen. Also check the cps.

I wouldn't get the hks. The filtering sucks and they get dirty fast. I'd get a aem dry flow filter(clamp on) or a Apexi filter and adapter.

My screw came out and fuel sprayed out. Not a ton but it was coming out. Replaced it with a good used one. Just my experiences. Bad dampner could have backed the screw out in my case.

The crimp isn't stock and might go to the little horn by the master cylinder but is missing the actual plug. Only thing I can think of for the connector is maybe the egr temp sensor if the harness is a ca harness. Also I doubt you will be able to buy that screw by it self. Best bet is the...

It'd be very nice not to open a heavy door all the time lol.

You can buy one. Hardware store should have it. You will also need to know thread pitch. And the size isn't the size of the head. It's prolly a 12x1.25 or 1.5. If you stick a 12mm wrench on the threads it should be close to the same.

What's super rich? Blowing black smoke?

2 black plugs are for the a/c fans. Bottom one doesn't get used iirc. Where does the top one come from? Also your fuel pulsation dampner is missing the screw in the middle. I'd suggest getting the screw or a different dampner. It can leak without it and it's a special screw.

If you remove it you could use sole Braided wire cover. They make them cut so you could easily wrap it around it and then use some zip ties or electrical tape to hold it in place. Make it look nice.