Search results

me too, done right they can be un-assumingly stunning... I am kinda partial to the initial D panda colour scheme... there is one rolling around waterloo (university area) that causes me to stare... niether did I but they made 40 @ $25K.... I think I would rather an un-official resto with a...

the wire is less than 8" away, assuming you did not remove your harness from the dashboard... look between the ac section of the HVAC and the radio... it should come from right around where the center console meets the dash on the passenger side.. on my 87 its a rectangle...

^give me until monday... I have 2 OEM steel spares... ^yeah but the t-top option first appeared in what 1974? specifically I have a friend with a 1987 Monte Carlo LS t-roof (rare model/option/colour/year) that I hassle about his leather bags..

^with 2 bungs.... you may need to buy one and modify it... I have done this to an SR20 outlet as they use an early/late O2 that corresponds to the ECU date...

never heard the Murano (1 sub) set - up, but in the FX45 (2 subs +amp) it definitely adds a nice touch to the low end. I think some may have an amp as an OEM upgrade but this did not. The FX45 that gave me the idea had a faulty amp. the spare tire mount was shortened 1", and I used the Murano...

^72 corolla?

what was the teams best finish last season?

lower din radio slot.... what have you there? active spoiler control? very nice, I may borrow I few tricks I have seen here...

I took some time to upload some photos for you guys... let me see your trunks... http://www.supramania.com/forums/showthread.php?38227-Let-me-see-your-trunks!&p=1885307#post1885307

this set up is nearly done, I still need to shorten the wires, raise up the hinge points about 1/2", but I was going for a sneaky set up that does not interrupt the functionality of the trunk.. Syran wrap ruins the photo, but its re-wrapped in faux leather top/bottom Nissan Murano...

^chinook??

^well played sir, well played.... Philosophical moment; those who cannot laugh at themselves, should not laugh at anyone.... In my own defense ST was kind enough to place their sticker in an upside down manner, so when the bar was installed backwards the label would be clear when the car is...

So I was buttoning up the rear suspension on tuesday, and while installing the rear sway bar (a suspension techniques) I came to realize that the bar is pressed tightly against the rear subframe mount 'washer'. That 3" round concave bugger that fits into the bushings.... I can see that it will...

^you can use a smaller unit from another vehicle..... you can also move its location to somewhere less obvious, then there are always the Environmental regulations.... and associated fines...

never really considered that.... This chassis has been stitch welded inside and out (from the front strut towers to the rear strut towers - leaving front/rear crumple zones untouched) - pretty sure that a-pillar/frirewall corner is the strongest spot on the car, but I suppose there could be a...

I have the driftmotion aeromotive 1JZ FPR kit, + USDM 550cc my issue is that given the amount of hose/pipe the FPR must sit above the heatercore outlet next to the brake booster... problem is, I have moved my engine harness firewall hole to this area and it is quite cluttered already... I...

^very nice, is that a little shine on the 4 corners?

^silicone removal solution is available from Rona/Lowes... home depot..... I've used it to clean up some high end flatware that was originally silicone'd to a retail display panel...now in my kitchen drawer...

on the driverside you are missing the cruise control vacuum thingy... its round...

Kinetik 600A battery with custom box integrated into the drivers quarter panel.... instead of a capacitor...