Recent content by Jason T

There is a switch you change for what type your running Swing valve = stock Poppet valve = External Link to all HKS EVC's with fitting manuels in PDF http://http://www.hksusa.com/faq/?ID=1647

Vacum feed pipe to power steering pump Part # 17303B http://www.cygnusx1.net/Supra/Library/EPC/291420/catalog.aspx?F=1708&P=2

Orginal moulding can be removed from steel panel Glue over top of 89+

EGR remove blocking plate from inlet and rear of head slap on ebay for EGR delete bolt on your EGR goodies Dont forget that heater water pipe is on the wrong side also Would hate to have to change that in the engine bay :3d_frown: Thats what hes got JDM EGR block off plates :biglaugh:

Result of no vacum to fuel presure regulator # 1 Clean lets loosen the rest + Rebuilt engine with scewed oil seals Rebuilt engine stock head stud tourqe 58ft dont work MMM'kay Rebuilt engine with scewed oil seals Twin gaskets wonder why that leaked Dont buy cheap down pipes...

Bad radiator cap not letting water to sucked back in from overflow

#1 Aristo never got 2.5 #2 SUMP as in oil pan Supra sump pan is at rear Aristo pan is at front Slump = Engrish speak good I Ask about "warranty" that should be entertaining

http://http://www.absoluteradiator.com/Radcap.htm

Yep Wifes car is MK3 Camry 2.2 clutch was fried so I replaced engine with new clutch attached removed as 1 unit due to subframe set up On the ST202 Celica's just pull the box from engine easy job Heres the camry TRSM http://www.turboninjas.com/camry/ Download the 5 spd section same...

Take the heat shield of the fn thing find leak replace gasket Bet ya its the gasket between turbo and manifold http://www.ma70.com/bishop92t/techtips/turboremoval.html

ARP BOLTS same style as stock will come loose and need to be retourqed APR STUDS with seprate nuts are a set and forget item

You need the correct flywheel to suit box type R154 is pull clutch W58 is push type...clutch plate cover bolt patten is very different so is depth of flywheel they do not intechange 7MGT is pull clutch...on right of pic 7MGE is push clutch http://www.4cefed.com/w58vsr154/w58vsr154.html

http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=19

Buy yellow bulbs . Once spot light lens is in your hand..... See the base that the bulb is cliped into Around the edge are a few pieces bent inward to hold bulb base in Bend these tags out to remove bulb base Slide in collar to hold yellow lens Place yellow lens inside...