Clint;1866362 said:Give Aaron a call at driftmotion http://store.driftmotion.com/static/i-1jzenginegasketset.php
Yeah i already Purchased it Clint
I'm taking the head for a valve Job and clean.
And i'm thinking i should do the Rod bearings.
Clint;1866362 said:Give Aaron a call at driftmotion http://store.driftmotion.com/static/i-1jzenginegasketset.php
Zumtizzle;1866366 said:With as fucked as that motor looks, I'd do everything!
And the hole in the pan is an Oil Level Sensor.
Turbo Habanero;1866367 said:full engine gasket kit
main bearings
rod bearings
piston rings
oil pump
wrist pin bushings
valve job
anything else i should do ?
IBoughtASupra;1866518 said:Do you have the option to take this thing back to the guy who sold it to you? Seems like he didn't want anything to do with it. Probably had sand in it and he tried to take the bolt off and couldnt because they stripped and then sold it to you.
If not, you will need to drill down the center and break each off. I will find the thread.
IBoughtASupra;1866521 said:Don't you guys have guns in AZ......................................................................................................................................................................................
IBoughtASupra;1866521 said:Don't you guys have guns in AZ......................................................................................................................................................................................
slowmedown;1866522 said:only about 95% of us lol
jordan that sucks about your engine. want a f-ed 2jzge bottom end?
IBoughtASupra;1866518 said:
IBoughtASupra;1866770 said:Jordan,
It wasn't a used engine. It was used when it came from Japan. Now it is pretty much junk that you were sold. Go back and talk to the guy. Someone else was there and tried to use the torx tool to remove those studs and that's most likely the reason they are stripped.