Search results

  1. I

    7mge vs 7mgte head

    Same same excluding the Intake Cam.
  2. I

    Block Prep

    Good tune and NO detonation they would be quite high, back in the stone age I ran my 3.4L Toyota V8 with NO IC, Pump fuel, meth injection, really low comp and 30 psi on Composite gaskets.
  3. I

    reduced size ac condensor?

    The aftermarket one I'm using this time is a little narrower than stock but does have double the tubes of the one Toyota used. (pics in my pics thread)
  4. I

    Questions about Hot tanking motor.

    All depends on the cleaning method used, if you do it the Rich way 100% need to be replaced if it's done the way I suggested and the solution doesn't eat the babbit material and the mic up ok no ;) If you have the replaced make sure it's by someone that has a clue and make sure they have the...
  5. I

    engine bearings

    King BiMetals :evil2:
  6. I

    Supra Stick V4 Speed Signal

    Yep right up until the SSv4 gets confused and can't count that high ;)
  7. I

    wilwood question

    Snap a pic of the calliper showing the pistons please.
  8. I

    Having fun with a soldering gun...

    Ign ring, cluster and so on! I still have to do all the switches (been putting it off as it's a fiddly pita)
  9. I

    mike from miami

    Sorry bit of a bum steer there it was another Sean I was thinking of! Starts about 1/3 down the page. (post 16)
  10. I

    mike from miami

    Pretty sure there's a shifter for a Soarer that fits a Mk3, I think SDJ70r did a write up on the install, gimme a sec I'll see if I can find it. arghhhh new PC is playing games with search.... :runaway:
  11. I

    mike from miami

    A big wallet and hammer ;)
  12. I

    mike from miami

    Start by reading this Mike!
  13. I

    Having fun with a soldering gun...

    You do realise you can buy direct fit LED's that fit like the stock bulbs don't you?
  14. I

    I didn't know coil packs cost so much

    So you're just "friends" ???? ;)
  15. I

    "Pre-89 Shine Air-guide" thread =0) NEED 25 COMMITTED BUYERS!

    ^^^ Makes me LOL everytime I read "Pig Nose" :D Maybe "Pig Snout" would be more accurate!
  16. I

    Questions about Hot tanking motor.

    Sounds like a great alternative, difference being most jobber shops don't have access or the skills required to do this job correctly Rich, you do.
  17. I

    Block Prep

    Thanks Rich! Appears I've stepped on a few toes with this subject, my advice is given to provide the best chance for success as I tire of the "Built a 7M and am having xxx issues" resulting in part outs a few months after kids have dropped ALL their coin into a car that "could" have been fine...
  18. I

    engine bearings

    Been some reports of ACL's found in 77 boxes recently Rich, NDC's are a great bearing never had an issue with them that wasn't my fault and wouldn't hesitate to use them again. What I do have an issue with is if you're paying a premium for 77 technology which the NDC's just don't have, here...
  19. I

    is it necessary to run a thermostat in-line with an oil cooler setup?

    Don't know if they're stocked anywhere there but "SpeedFlow" are a locally produced alternative that are much more affordable than Russel/Earls and damn good quality.
  20. I

    wilwood question

    Might have to unplug the feed ports if they're capped or open the bleeders before the pistons will retact fully.
Top Bottom