Search results

  1. hvyman

    boost drop - 57 trim ct26

    That is likely te problem. It's a tiny exhaust housing and wi get outflowed easily in the upper rpms. Usually falls off about 5500.
  2. hvyman

    AEM v2 No Start Sync.

    Igniter is not the problem if the coils are not getting power. You check all the fuses inside and out?
  3. hvyman

    Fuel pump hanger question

    Why didn't you just remove the hanger with the tank. Much easier. I drill rivets out.
  4. hvyman

    Turbonetics Tc76??

    If it's journal bearing might only be a little more expensive than the bw. So it's not like it's an expensive turbo in the first place as well
  5. hvyman

    Turbonetics Tc76??

    How much power are you looking for? That's a 76mm. Quite large and with a big housing is going to be pretty laggy. A 62mm or 67mm would usually be better suited for a 1jz.
  6. hvyman

    Just Hit the Detroit Auto show Toyota FT-1

    automatic meh.
  7. hvyman

    Fuel pump hanger question

    Could just use another rivet. OR use a heat shrinking ring terminal.
  8. hvyman

    morganson's COP S-Type setup

    Could just cut the connector off the coil pack harness. Also might be the same as the cps connector.
  9. hvyman

    coolant temp gauge issue

    Connector has nothing to do with resistance. It's just a connector.
  10. hvyman

    Hi from Australia

    Sweet Welcome.
  11. hvyman

    Suspension Overhaul Questions

    Ya mine are seized. Not looking forward to doing them. My rear sphericals also have play. What did you use for the spherical bushings? I was thinking a socket and a pulled to press them out on the car.
  12. hvyman

    Suspension Overhaul Questions

    They can eventually snap. It's not a huge issue with stock sway bars tho. With stiffer sway bars adjustable ones are wise tho the metal link will work as well.
  13. hvyman

    1JZ Swap into Miata - No Start, no fuel, no Injector Pulse ... Expert Suggestions Pls

    Could be a bad crank or cam sensor. Can be checked with a scope.
  14. hvyman

    1JZ Swap into Miata - No Start, no fuel, no Injector Pulse ... Expert Suggestions Pls

    You still have the grounds on the intake manifold.
  15. hvyman

    Suspension Overhaul Questions

    You would need front subframe bushings. Also can get upper control arms and ball joints from rockauto.com
  16. hvyman

    New bearings, washers, and oil pump to provent crankwalk?

    Ya disable the clutch start switch and start the car with foot off clutch in Neutral.
  17. hvyman

    Advice on New muffler

    Nur spec is a loud exhaust. Apexi n1 is a nice sounding exhaust but can be loud.
  18. hvyman

    New Coilovers!! HELP!!!

    Pbm will prolly go the lowest.
  19. hvyman

    Ridiculous 1000HP 7M Street MK3 Build

    So how is your tig holding up so far?
  20. hvyman

    HID question

    Get a better ballast. Mine have been maintenance free for over 6 years.
Top Bottom