Recent content by 7m2ner

bump* I understand I no one can help with my second question, but could any one answer my first question about the oil pressure, has any one ever had the same problem after shimming the pump?

Hello everyone, well to start off sorry for the long post, but I have searched but come up with nothing use full. It is a fresh motor, and it is a newly upgraded 57 trim Ct-26. First question is that when the motor was started after it warmed up the oil pressure was at only about 5-6 psi, when I...

Thanks to all for the input, and sweet cant wait to see the pics, keep us updated thanks RogueSteel

Well yea I mean the whole Kit in general that they have that comes with the intercooler, and what looks to be pre measured pipes with the all clamps and couplings. I don't care for the BOV since I already the a HKS SSQV but any input is greatly appreciated. This is the kit...

Hey every one, just wondering if any one has use the kit that driftmotion sells for the 7m, if so how did you like it and if you had any pics of it installed. Thanks to every one.

Hey hows it going, well yes the chip I was talking about for the vpc is the 550 injector chip. the mods to the car are, eagle rods, .020 over JE pistons, fidanza flywheel, 5 angle valve job, cometic head gasket, all arp hardware, new oil pump, driftmotion oil pump hose, titan cam gears, greddy...

Hey everyone, so I just got my chip in for the VPC that I am using on the new build, i am using it with a S-AFC2, I leaned out the VPC to get the car to start, it is idling high (1600), but smooth. When I try to drive the car if I slowly give it throttle it start accelerating ok, but when I give...

Hey everyone, so I fould a thread to install the VPC, and on the thread it says that the grey wire that should be there, and of all teh four wires I dont have a grey one, I have a yellow wire. I was wondering if I should move the pin location on the harness so that it matches the grey wire...

yea I checked for boost leaks first and found nothing, I am trying it on the stock afm rite now, and I do have a AEM wideband. I have a HKS VPC that I wanted to use after I got the car running better, because I didnt think I would run into this big of a problem. So would you guys recommend me...

Hey everyone, so I have run into yet another problem trying to get the car running. So last weekend I was working on the car I finally got it running, and I let it run so it warmed up to opperating temp. It was idling rough, and I went to try to drive it to break in the motor, and as soon as I...

Hey thanks a lot for all the help and info, I am going to check them, I have a feeling that they might be switched, because I had just placed them in the same possition of the other connector. I will let you know what happens when I finish. Thanks again, Ricardo:icon_bigg

So I built up the oil pressure, and then I put the fuse back in, and connected the coil pack, I tried to start it, and still no pump action. I ran it directly from the junction box, to get fuel pressure, and it finally started. I know I should have stated it before that I had to change some...

Hey everyone, I have searched and found nothing, I am trying to finish up the 7m build, and I was trying to crank it over to get oil pressure before start up, and I noticed I am getting no fuel pressure at all. its a new walbro, and when I run it straight from the junction box in the engine bay...

Hows it going everyone, I just had a quick question, because I am installing my AEM wideband. I didnt recieve the install sheet from the wideband, and I dont know where the blue and white wires go, red and black are obvious, but I am lost with the other two. Any help is appreciated. Thanks Ricardo

Sorry to hear that happened man, I hydroplaned into a curb in the rain a bit over a year ago as well (not drifting), and I know how you feel. I ended up trying to fix it by replacing the only thing that looked bent which was the left rear control arm, but the wheel still sat a bit crooked. I...