What did you do to your supra today? Pics
- Thread starter boostinsupra
- Start date
..... Will change first thing next year thou... Not sure what its going to be anymore.... Could be URSLOW or 7M-GTE or JZ THIS or 321GO or RCE ME or KEEP UP or I BOOST or STOCK or B16 KLLR
AbsoluteSpeed;1946177 said:
Ya haha, I like 'keep up'
Sent From My HTC One S using Tapatalk 2
Went out to test my new turbo/qsv and went out to a back road to dial it in and a coupler blew. 
Going from a driftmotion 60-1 to a comp turbo billet, ball bearing 6265 over a qsv didn't impress me at all. Do I need to put a boost controller on it?
Sent From My HTC One S using Tapatalk 2
Going from a driftmotion 60-1 to a comp turbo billet, ball bearing 6265 over a qsv didn't impress me at all. Do I need to put a boost controller on it?
Sent From My HTC One S using Tapatalk 2
Installed my ronnie k subframe bushings.
And bought a truck on Friday. Now I finally have something to haul parts!
And bought a truck on Friday. Now I finally have something to haul parts!
^nice truck. Eco boost?
I got my newer climate control installed. The green numbers are going to need to be replaced.
I got my newer climate control installed. The green numbers are going to need to be replaced.
AbsoluteSpeed;1946305 said:
Yup, EcoBoost. I pick it up Monday night. Can't wait!
Nice job on the climate control!
A few more pieces.
Front and rear upper control arms with Energy Suspension bushings.
Front lower control arms
Driveshaft is in and engine is humming. Most of the electronics are wired in (still fiddling with the Apexi RPM gauge), and we are good to go.
Later this week Seth is going to do a street tune of the car to get her running nice and smooth, at which point she will get released back into the wild. After that I will schedule an hour of dyno time to fine tune the rest.
GodDAMN I missed her.
Later this week Seth is going to do a street tune of the car to get her running nice and smooth, at which point she will get released back into the wild. After that I will schedule an hour of dyno time to fine tune the rest.
GodDAMN I missed her.
Removed the old ruined tint except for some of the hatch window tint, which is a pain in the ass and scary because of the defroster stuff.
Tonight I was finishing up removing the hatch tint, major pain the ass, I had to use a steamer and a razor blade to get the majority of it off but there are still some small strips on the defroster, so I sprayed the window with some 409 and put a trash bag over it to let it the sun heat it up in the morning and wipe it off hopefully. I hope I did not damage the defroster but I was very gentle when I was near it with the blade.
I used extra fine steel wool for the defroster lines, doesn't damage them but takes off the tint
Took the plunge and swapped out the electric fans for the NA-2J fan that I got from another member. What's the best way to tighten down they bolts?
Before:
During:
After:
Does this look a little close?
Before:
During:
After:
Does this look a little close?
I dunno dude, that looks awfully close to me. Any movement from the motor and it's gonna chew on something.
Finally got Huper Optik Ceramic tint done and noticed a huge difference when I sat in the car.
