Search results

That looks the mkiiisupra.net club carBQ and the supra for sale in this thread must have two engines lol

I had exactly the same knocking as this and it was loose cam pulley bolt Sent from my GT-I9505 using Tapatalk

Anybody ever fitted a system that pre pressurises the fuel rail at IGN on prior to cranking on a 7MGTE? I did it the other day and it works brilliantly, cuts cranking time to 3 compression strokes (1 turn of the crank) and illuminates heat soak completely too EVEN without fuel pressure VSV in...

I just renewed mine as the tank was out

Sexy underneath pics Its fresh underseal, not oil lol Tank removed

Thanks guys, the inlet/plenum is powder coated along with all the other silver bits under the bonnet. Engine also has ARPs holding the bottom end in place, HKS "stopper" 2mm mls gasket with ARP stud/nut, TurboTechnics stage 2 turbo, Titan down pipe, HKS high power zorst, Aeromotive adjustable...

Hi guys, not been about on here for ages but big user of www.mkiiisupra.net in the UK Anyhow i finally getting my supra to look how i want it to after two years so thought i stick up some pics........

Have a look on www.mkiiisupra.net at the technical section and look for the guides, i did one a while back for quick TPS adjustment. All you need is a multi meter and a bent screw driver and it takes 10 mins to do, and you will need to check/adjust timing after to get best results. Infact here...

Right guys, i got all excited over nothing! both them diagrams dont match my pinout on my MA70 turbo auto, the connections of the 3 next to each other wont work and the engine ecu dont have gear possition info either so i need to wire this to the ect ecu which isnt a problem BUT i need to know...

Does a mines ECU work in an auto 7Mgte powered Supra?

Gofastgeorge your a star! thank you so soo much!!!

Anyone???

Hi all, has anyone got or does anyone know where the wiring diag can be found for an HKS A/T gear possition indicator ?? i got one to fit and its only 5 little itsy bitsy wires but i got no daigram for what colour to what colour to connect??? thanks

i was under the impresion the stock Toyota studs where hi tensile, so i followed suit! and if you ever intend to remove them at a later date, say after a few 1000 miles, mild steel will just sheer off when the nut rusts onto the stud. as far as the thread lock goes it was more to stop the...

I didnt mean do that to your Golf!! Unless you fitting MLS theres no need to prepare the block that much for stock gasket... I used a sharp gasket scrapper to remove the remnants of gasket from block, these where too big to go anywhere, i then prepped the block with 600 grit and WD40 for the...

i see it said "mkiii has no friends yet" you sad bastard, lol!!!! more beer i think!

Been a bitch of a year, lots of shit has happened and not all good, still i got it to this state over the last few months ready for Jae over here in the uk which was a fantastic weekend.... Currently with titan d/pipe, tanabe sh medalion 3"zorst, hks vpc, hks fcd, aeromotive fpr, walbro h/p...

hello! nice narrow body.....

my 1988 3.0 turbo, was an n/a but previous owner converted it to tubby, nothing too way out but im pleased with it, only got it last year!

Titan down pipe like this is excellent replaces turbo elbow, along with this i have a 3" Tanabe system and HKS vpc, boost went to 11.5 psi BEFORE boost controller used!