Search results

The 7mgte is a stronger block with piston squirter too.

I am currently running a CX RACING CT-26 and it seems good so far. Builds boost quickly hits 3 psi by around 1800 rpms and 5 psi by just over 2000 rpms and then up tp 8 if i lay into it. I saw it go to 12 psi once and only once ??? not sure what that was about... My only complaint as of yet...

Thank you for the great info.

Mine misses a little at idle. It misses pretty bad under low load and vacuum. Under boost is seldom misses. its the cruising at low load missing is annoying. I suspect bad fuel/detonation. It got worst right after fueling up at a gas station in a different town, it started missing a lot so...

Nice story. It put a good smile on my face just reading it. I cant wait to pull on cars in my supratruck. ;-))

Does anyone have a resistor I can buy. Toyota discontinued them. I'll be checking with local junk yard's this week but I thought that somebody must have part car with one. I'd really like to get it all dialed in sooner than later.

I have at least a hundred miles on it now and it seems fine. I love the torque and the power of this motor. My truck is wicked now. I am so glad to have my project back on the road!! So is that resistor changing the voltage to the injector or just distributing power? I think it would have...

This Truck has the heart of a Supra. A 91 7MGTE to be exact. I think my truck has an attitude. So much torque down low and such psycho power. I built the exhaust and selected my turbo for quick spool and man it does. It starts boosting in the upper teens and is nasty after 2250-2500ish. I...

ITS ALIVE!!!!!!!!!!!!!!!!!!!!!!!!!!!!! The resister for the injectors was missing from the harness. I knew it was something stupid. It is running a little rough but I drove it around a bit last night. Its a nasty Beast!!!!!!!!!! so I just jumped and powered up the injectors because I...

Head gasket leaking coolant exterior by chance? Just my thought. good luck I hope it is just spilled coolant for your sake.

All the timing and CPS are right where they were when I bought the motor in running order a few years ago (projects are expensive and so a girlfriends haha). I had a friend and one hell of a mechanic come over after work today and the CPS failed the OHM test it was open in all three terminals...

I swapped a 91 7mgte in to my truck so this complicates the problem but... I have been reading for days and can't find the answer so we are here. My fuel system is a 20 gallon fuel cell with and msd efi pump and 8-an lines. the pump is wired to a relay that is switched from ign. It has...

Scrap that Power thief and get an Electric fan!!!!!!

Good luck Check for continuity between the gauge and sending unit it will tell you if your wiring is good.

Try searching google images - 7mgte I found a lot of pics this way, quick.

Ya thanx I can't wait to hear it run!!!

Crap Does anyone have a wiring diagram to share.

almost ready to Fire Swap!! but can't find plug? It is a '91 7mgte. Can someone look under their hood if you have a 91 ish supra? I have a few pics up in Members Rides if your interested.

Does the ecu care if i gets no signal from the sending unit? I put a 91 7mgte in my 81 pickup 4x4 and I am running autometer gauges though out. I just want to know if it is going to make the ecu shut the motor down. Has anyone else installed after market oil pressure gauge?