Search results

I was told that it would work. I also have a, I think the manufacturer is senkei, KG-810 that I have available. I did find that when I changed to the one I have now that I had done the wrong thing and attached it via the spade instead of the button on top. Sadly this didn't fix my issue, now my...

Hey guys, I just started to get my 91 turbo back up and running and I noticed after I changed the oil pressure sender that my Oil pressure gauge is pegged as soon as the car gets started. I am trying to figure out the issue, but my Haynes manual doesn't mention this at all and all of my...

Hey guys I have spent a little bit of time looking, but haven't found much to go on and I am terrible at reading wiring diagrams. 12v IGN wire in the engine bay that I can use as a signal wire for a secondary fuse block that I plan on wiring all of my accessories to as well as may be an electric...

Why thank you very much. That's the one, but no one knows where it goes. Haha

Hey guys, it has been forever since I have been on and I'm sorry for that, life got in the way. But now I'm moving and I have to finish my supra so I can move it. While wrenching I came across this plug that I have no idea where it goes. Also, does anyone have any ideas of an oil leak turbo...

Drill extra holes around the bracket?

I plan on mocking up a sheet metal plate that stabilizes the coils and bolts to the factory coil mounts. Let me know if yours works an if you are willing to make another one and I might buy it off you. Currently there is no stabilizers for my coils and I get a decent miss because of it.

Gary, you have to build it yourself. Driftmotion has coil harnesses you can get to modify, and they also sell the coils and wires.

Do I need to plug it though?

What is this threaded hole near the block side of the pcv vent tube. There is nothing in mine, should I find a bolt and plug it. What is it?

No one knows?

Sorry to revive an old thread and jack it, but does anyone know the thread size and pitch of the a/c and the cooling fan switch? I'm trying to do a clean install of my flex-a-lite fan controller and am trying to find a place to put my sensor, I figured I took my condenser fans out and my belt...

I'm glad everything I was worried about was wrong. Good deal.

I came into and aeromotive 13301 afpr a while back and everyone advertises it as needing 100 to 250 a gallon per hour fuel pump. I have a walbro 255 lph fuel pump and that comes out to about 60 gallons per hour that's nowhere near the 100 that I would need. When I was looking at Walbro 400 lph...

Sorry it was such a pain, just wanted to do it perfectly.

15A got it, Probably what I'll do then.

Anyone know the max amperage for the fuse on the cig lighter off the top of their head, I'll go look if no one knows. It's a good idea, but I am already running a profec b-II off of mine, the light for my boost gauge, and using the lighter to power my garmin which I use cause my speedo stopped...

What specific wire did you use to power your turbo timer, I understand the way it all works, just need some one to tell me exactly which wire/s to tap for power. It's an AEM uego if that matters at all. The MAP ECU tells me to ground it through the ecu grounds, but leaves me with no suggestions...

No one has any pictures of how they wired their widebands into their car?

I do understand how a relay works, just figuring how to do it all cleanly. What do you mean by ignition wires. Are you talking the ignition switch or the literal ignition wires. I know I'm asking a whole bunch of questions, but I'm trying to find the cleanest and safest way to set this up. If...