Search results

Is the light on with the key out?

They make alt drop down kits. I think bic and arz make them. I also recall but cannot confirm that it needs modification at the back because it hits the brake booster. With the costs of moding it you might as well spend the extra couple hundred and get one from sethron. My opinion.

Not sure. Will check maybe later today when I go over to my buddy's house since its his motor. Edit: What also was weird is the no.5 rod bearings were all gold and rough but the crank was good and did not need to be cut.

Just making sure because when i pulled the pistons all the rods could move freely but the pins would not move in the pistons. And Toyota says you need to heat the pistons to 140*f to push the pins in. When i was taking apart the engine no.5 wrist pin actually moved knocking out the clip and...

Ya but if something wears the line going into the cabin like heat, cheap hose, something rubbing on it then you got 40psi of oil ruining your interior. Electric would be a better choice.

you sure you are not a tooth off?

Yeah that one and theres another one too.

ok cool.

http://www.bobistheoilguy.com/airfilter/airtest3.htm Edit: couldnt find the other one where they tested all the filters for our car but i seem to remember that k&n and hks were dead last.

did you have to heat up the pistons for the pins to stick? or did you just slide them in and run it?

I never stripped the caps. Just washed them and painted them and never sanded them. Never sanded anything. Looked great but the caps looked good before. And i know your supposed to sand so the paint sticks but it stuck. I really did not wont to mess with the caps at all. Only problem i...

I just painted the center caps. They were white center caps and i just washed and painted them. I painted them at the same time but off the wheels. After about a year they still look great for a quick job. With the paint aircraft stripper i just sprayed it on(went through 2 cans for all 4)...

Yeah high heat black. Idk if it was 500* or it might have been the 2000*bbq paint but i forget. Did not bake the wheels. If you use the aircraft paint stripper, you just spray it on and wait like 15-20 min and wash it off and they have the nice alum lip. Tape off the lip and i applied...

Air craft paint stripper from kragen and some high heat black with clear coat all rattle canned.

Looking good man.

Does it say ma70 big on the firewall is that what your referring too?

Hondas and rx7s need to be reved high in order to get anywhere fast if there even fast at all. We have turbos. Even if your motor can handle the rev's unless you have the turbo for it its not going to go very well.

its cool it happens.

those are some massive ic pipes.

why not just get a 90 harness?