Search results

  1. I

    Starter / knock sensor interference

    KS in the wrong hole maybe?
  2. I

    Advancing / Retarding Timing....

    Tanya: LMAO Figgie covered it pretty well I just thought I'd clarify that point as B2 seemed to have misunderstood a touch! ;)
  3. I

    It's alive!!!!!!!!!!!!

    SH/JJ: LOL ;)
  4. I

    Advancing / Retarding Timing....

    Advancing = firing further away from TDC Retarding = firing closer to TDC
  5. I

    Group A's group a rebuild

    Steve: :(
  6. I

    Advantage Using GE pistons on GTE Engine?

    GE Pistons will give you higher staic compression so more power off boost but less overhead for adding in boost before it detonates. You'll need to drill and tap the block for the second KS it's 12x1.25 metric You'll also need to sort an Oil Drain from the turbo as the NA isn't drilled and...
  7. I

    Got a new car today

    Very bad car in a roll over situation! (I wouldn't own one without fitting a roll bar)
  8. I

    It's alive!!!!!!!!!!!!

    SH: 1) Should I change my fluid after 500 miles like I read somewhere? The transmission fluid is what I'm refering to. Nope it should be fine for quite some time! 2) Is Lucas 90wt. gear oil a good fluid to use in a manual transmission. If not, what do you reccommend? I'd go for...
  9. I

    LOTS of noise from turning the wheel...

    Belt tension?
  10. I

    WHAT...THE...F*CK!!!?!

    Sporks?
  11. I

    I finally appreciate the BHG

    Just putting mine back together after a "stupidity induced BHG" ;)
  12. I

    It's alive!!!!!!!!!!!!

    SH: Well done! It's a used trans? Fresh Oil when you put it in?
  13. I

    Subframe Mount/Frame Rail

    Syst: LOL you have no idea just how tempting that idea is right now ;)!
  14. I

    I need hot garage pics!

    You moved to Japan Mass? ;)
  15. I

    Subframe Mount/Frame Rail

    Syst: Only hassle with fabbing a part to repair that is our cars are made from Hitensile sheet, this allows the material to be much thinner, if you replace it with plain jane mild steel go twice as thick it'll be heavier but around the same strength. You can cut a section from a doner car but...
  16. I

    Why do people insist on starting shiznit on the forum?

    Wills: You really need to back it down a notch or ten.......
  17. I

    BosoMKII's project! 56k cut your head off

    While the stock mani may be ugly it works very well! ;) Micky: Only Aussie delivered NA's or NA's going to Hot climates got the Oil cooler my guess is your motor is a JDM NA.
  18. I

    Jaguar_5's 87 Turbo Build

    The machinist would need the bearings in hand then grind the crank to suit not the other way around Jag!
  19. I

    Jaguar_5's 87 Turbo Build

    I went with the 77's this time! (may need some custom selection and fitting but a very advanced design of bearing)
  20. I

    Best Pick up lines

    Going for the charity fuck?
Top Bottom