Search results

  1. I

    Castrol Edge RS...The Best Oil on the Market?

    LOL Hence my ;)
  2. I

    Yellow 13

    He was behaving himself and not fucking up so was left alone....
  3. I

    Castrol Edge RS...The Best Oil on the Market?

    ;)..
  4. I

    Yellow 13

    I knew cos I'm a Mod and I have moddly powers ;)
  5. I

    Type of Vented Gas Cap

    Too small a cap vent will limit pump volume as it tries to create a vaccum in the tank.....
  6. I

    Identifying Cams

    2mm is a huge difference unless 1 set are totally worn out and dead.
  7. I

    Project Cherry Widebody, finished! (New pics on post #451 and #511)

    Tek: Not really sorry.... They were actual pics and have been lost over the years I just have the few I scanned.
  8. I

    Started the Valve Cover gasket replacement *pics*

    ^ Wrong Gasket for sure
  9. I

    Supra on Pinks!

    Shawn: Just watched the vids! Very well done <golf clap>
  10. I

    Tlo86's 2JZ Build Thread..

    It's the cast in lug on the lower right front of the block I remember seeing a post where someone had snapped it off a fully built motor :( (pretty sure it holds the Alt on stock)
  11. I

    Supra vs. Chevelle Pinks Videos! (Post more as you find 'em)

    << NOT a drag racer in the slightest but that was awesome :D
  12. I

    Tlo86's 2JZ Build Thread..

    Tlo: Looking good :) Just a small heads up you may know about already, there's a Lug on the front right side of the Jz block (can't remember if it's Alt or Pwr steer but I think Alt) that can break off :( It's just something to be aware of when moving your motor around. (saw you mention...
  13. I

    If you could have any aftermarket part what would it be?

    Make sure they put some holes in the shipping box ok ;)
  14. I

    Learning to weld

    My welds hold part A to part B no probs, Jon's welds are some of the prettiest I've seen done by a human along with Ron's! More like art.
  15. I

    sce copper head gasket

    Sounds like a single wire that starts between the bores and does an S around 2 bores and joins back on itself. Would take some trick machine work to do compared to a traditional groove around each hole, and the wire would need to be fitted very carefully where the ends butt up against the...
  16. I

    Learning to weld

    Would love to ;)
  17. I

    Learning to weld

    Been welding 35 years and still learning ;)
  18. I

    If you could have any aftermarket part what would it be?

    Anything I can think of I usually end up building ;)
  19. I

    Project Cherry Widebody, finished! (New pics on post #451 and #511)

    Tek: Best way I found to highlight the changes when I did the widebody 240z was to park a stock one beside it :)
  20. I

    aem tru-boost settings

    It's easy to remember things when there's very little else in there sonny :icon_razz <jk>
Top Bottom