Search results

I would ask Natalia if you she is a slut and does she like it when it is PIITB! If she says yes, where do the payments get sent to? ;) hehe

<-- takes popcorn out and watches with close intrest.

can you get pics? Camera phone will work.... I have an idea but visualls usually help ;)

audiophiles... lol I call those idiotphiles... as they are the ones spending 1000 for f'ing speaker cable that is nice and purdy!

agreed with Jetlock I used to have bags upon bags of aerospace crimps that I had in the airforce. I gave them all away when I got out since I didn't have the nice crimpers available to me that I had in the Air Force.. of course ,now wish I didn't but oh well. Plenty of aerospace electronic...

rod bolts need a torque value BUT ARP considers that inaccurate. For ROD bolts/studs you MUST measure bolt stretch! That is the only proper and recommened way of installing rod bolts!

pointless and off topic you want to continue this convo. pm me. I am done here

about every thread on this forum, wow your statistical analysis is nothing short of fnear sighted and flawed in almost every single way possible. Just because I cut through the bullshit and lay it down like it is does not detract from the facts posted. feeling be damned. As for the 7m coils...

bud that is for most any coil including the all mighty gm dual towers. As for that thread in BL land. Garret does not publish the information in neither their pdf nor site. So before taking someone else statement at face value as I was told, I researched!!! yes that is right, it is quite...

google electrical pigtails for the answer

that MIGHT be the case or not. It depends on the mH of the coil itself and the primary resistance. We know for a fact that the 1jz coil has more mH as it takes a longer dwell time to acheive peak saturation. Otherwise BigAaron would not have had issues using the 1jz coils on the stock 7m ignitor.

hate to break it to you but the 7m dual coil towers have a dwell time of 3.3ms. Trust me it has enough breath for about 12,000 rpm before "it loses it effectiveness"

make fun? who said I was :p This is a mod, see the generator BOLTED to the car, see the A/C to the side of the car instead of inside of the car.. MOD. And I bet that it probabaly will cool better than stock A/C to!

umm dude that is not a HUD that is a $6000 dollar piece of datalogging, monitoring and display device. Motec ADL. Not the SPORT ADL.

ahh might be two problem cold start injector is bad.. disconect it see if it takes care of that. Check the cold start injector sensor in the temp housing :)

Well then here is the solution to all your problems how to install a/c in you non a/c equiped car... raise the value for having a very cold a/c! All parts availalbe at your local homedepot. Not availalbe for export (sorry IJ.! ;) )

gixxer a rough ilde.. it start to surge (ie rev up and down)? if so, you want to look at timing, You are probably at 10 right now might want to lower that to 8 to see if takes care of that. That is a common problem especially on stand alone cars when timing is too advanced.

400? No need for a techtom upgrade then.

correct except techtom desolders our roms and plugs in a daughter board on the 7m ecu with the stock rom

used is used I say. oh well. hope you get the money back!