Search results

  1. I

    Fat Bastards......

    While I'm flattered by the attention CK please stop PMing me for pics ;)
  2. I

    Taser e-mail

    My Sis sent this I usually ditch all her crap but found this one funny :) Subject: Taser Stun Gun...Just try reading this without laughing till you cry!!! Pocket Taser Stun Gun, a great gift for the wife. A guy who purchased his lovely wife a pocket Taser for their anniversary submitted...
  3. I

    my new 88 turbo

    Very nice find then! I got mine with 160,000 KM's 10+ years ago and back then that was low mileage ;) Look after it it's worth preserving! (BTW you do realise we have "MultiQuote" here? see the little icon next to Quote? just click that on each post you want to quote the click quote on...
  4. I

    Has anyone does an Air-to-water intercooler setup?

    I've ran 3 different W2A systems all from PWR, they kick arse in stop start boosting situations as they're active and don't heatsoak. Once you get over 500rwhp the hardware becomes HUGE and hard to fit in a Mk3.
  5. I

    injector duty cycle at idle?

    1.1% 825 rpm 1000cc RC's full sequential.
  6. I

    Looking for these wheels

    A tank of gas is worth more than a few of the cars here ;)
  7. I

    block talk

    Not really sure what you're asking?
  8. I

    Starter help please

    Mechanical issue with the actual switch on the column then.
  9. I

    block talk

    Block differences are in the pics below click them to enlarge I've written what to look for on em, the light block is an 87T the Heavy is my New 93T from Toyota. http://ij.supramania.com/blocks00.jpg http://ij.supramania.com/blocks01.jpg http://ij.supramania.com/blocks02.jpg...
  10. I

    Starter help please

    The key got stuck on start?
  11. I

    Starter help please

    91 should have a tapped starter with no nuts? Look at the starter relay. Describe the symptoms please, we can't help without information.
  12. I

    Need help...

    My "guess" on the timing thing is the balancer has "slipped" it's outer ring and TDC Mark is no longer correct. Pull #1 plug grab a chopstick and slide it into the plug hole so it's sitting on the piston, turn the motor by hand and watch the chopstick rise. There will be a few degrees of...
  13. I

    Gauge Cluster Needles: Paint Question

    The OP asked a question I posted what I'd do YOU are the one blowing it out of proportion Goon.... :nono:
  14. I

    Oil Cooler yes or no?

    This is how I did mine, the rubber isolators are early RX7 oil cooler mounts. http://ij.supramania.com/icpipes16.jpg http://ij.supramania.com/reassembly01.jpg http://ij.supramania.com/reassembly06.jpg
  15. I

    Supra Shirt, (SM approved)

    One of the Mods did ;)
  16. I

    my new 88 turbo

    Nice find! Any reason the KM's are so low?
  17. I

    Gauge Cluster Needles: Paint Question

    Sarcastic prick :icon_razz
  18. I

    Gauge Cluster Needles: Paint Question

    Antiglare ;)
  19. I

    What?!

    LOL ditto ;) You have the standard drain fitting in place that I mentioned earlier it's a 3/8bspt fitting with a M14x1.5 tapered seat plug that screws into it. The plug seals with a taper cut on it's end and another female taper inside the fitting NOT on the threads. If you're concerned...
  20. I

    Leak *PIC*

    The squashed tube isn't helping it seal ;) I make an aluminium hollow sleeve to reinforce it so it can't collapse.
Top Bottom