Search results

  1. I

    Is there any REAL advantage to a dual split downpipe?

    At most there "might" be 5>10 rwhp in it....:nono: Well within the error margin on most dynos and operators.
  2. I

    --Golli's MA71 build

  3. I

    eraezer - Supra MK3 -89 -Swedish Build

    Don't let it put you off people here tend not to comment too much or get involved but still follow threads closely.
  4. I

    freeze plugs

    Wire brush won't remove any material, sand paper will.... One like this that's slightly larger than the holes.
  5. I

    freeze plugs

    Wire brush in a drill would be faster/better.
  6. I

    1jz head, keep it or send it back.

    The gouge in the first pic is cause for concern being so close to the water passage, even if it's surfaced that's still going to be there.
  7. I

    look at what i found while at work in my garage

    It's a turbine wheel ;)
  8. I

    new in town wad up!

    And the problem with first impressions is you only get to make them once.....
  9. I

    are these arp bolts

    Stock
  10. I

    What is this? (part of turbo)

    Not really sure what your question is.... Last pic is a Comp wheel and a Turbine wheel side by side.
  11. I

    9.1:1+ on boost 10-12psi

    You're forgetting Squirters and the 2nd knock sensor.... Same basic engine.
  12. I

    freeze plugs

    Very much doubt they're stainless, it's too hard.
  13. I

    freeze plugs

    Usually not needed for brass it's fairly dead anyway. Yeah guess that might help but you won't have much of a window to get them in before they're back at room temp.
  14. I

    Rebuild of 7mgte head

    Damn Lad you're DOOMED don't listen to that guy ;)
  15. I

    r154 top gear speeds?

    In the stock size?? (again didn't say they didn't exist just that I hadn't seen ZR in that size) My 7M was 28 highway and 20 town so yep 02 sensor would be the first suspect!
  16. I

    Camber Kit

    It's a bit of a hack though and the wheels still end up too close to the back of the car (ie: NOT centered in the wheel opening like normal viewed from the side)
  17. I

    R154 swap

    Check the TPS per the specs in the TRSM.
  18. I

    Camber Kit

    There are JIC arms if you want to add a pileOneg camber for racing but the A70 front and rear suspension has a good range of adjustment stock so most times you're fine for a road car, only "gotya" here is in the rear if you lower more than 2" you run out of adjustment. I "corrected" mine by...
  19. I

    freeze plugs

    I use a socket that's -1mm of the plug ;) (I have an old fucked extension so I'm not hitting the socket/hand) I don't do enough to make or buy the correct tooling, what's VERY important is to get the plug in with a minimum of hits, a few small taps to centre it then 2 hits to seat it if...
  20. I

    Camber Kit

    Just to be 100% sure of what you're asking can you post a pic of what you mean please? Doesn't matter if it's for another car.
Top Bottom