Search results

  1. I

    What are you reading?

    "After the Fall" a collection of short scifi stories.
  2. I

    Unleashing The Beast... (56K Beware!)

    Studs are only meant to be finger tight in the block.....
  3. I

    I've got a new party trick

    That's the cunning part, they can't get traction on the wet tiles so you're safe ;) (till you go to sleep)
  4. I

    I've got a new party trick

    LMAO here :D
  5. I

    "How much supra can you put into a truck?" build

    Stock ISC will chew up at least 4 outputs and if wired as stock 6, I'd got for a 2 wire solenoid from a mid 90's Ford.
  6. I

    New MKlll Owner

    My Condolences ;) there's NO escape you're one of us now! :evil2:
  7. I

    My 00 4runner!

    SCORE! (have you priced them yet?) I'm thinking pizza and beer for your Bud!
  8. I

    AFPR Ebay Question

    A1000-6 is what I've used the last few times nice stable reliable reg.
  9. I

    Just dynoed the cressida on pump gas.

    That's ok as long as you only THINK it :p
  10. I

    Synapse BOV surges when recirculated, ideas and advice please!

    Did this on a buds car awhile back, machined up a fitting with a flange on it then we cut a hole in his accordian slightly smaller than the fitting's od and siliconed it in, let it set then slide the connector hose right down to the rubber before clamping and it's 100% leak free. If the...
  11. I

    Here's a problem for the pro's

    My "guess" from the limited info provided is the installer has connected the white/black ground wires that normally connect to the head on the intake side to the 12v+ Post on the starter......
  12. I

    Just dynoed the cressida on pump gas.

    Glowing header run was a damn long pull Wes, nice numbers. People may not think I'm such a nutbag with all the coatings/wrap/sheilding if they saw this ;)
  13. I

    Differential noise

    Have a look at the subframe where the snout of the diff pokes through, common for them to crack due to loose/missing bolts. Bolts were either m12x1.25 or m14, best bet is pull the remaining one to measure. (leaning more towards m14 as the Tq spec is 122ft/lbs so much higher than the usual...
  14. I

    see through 370z and the story behind it

    Seriously cool but it has a shitload of windage ;)
  15. I

    two left over plugs?

    Always ran the stock internal hardpipes and fittings here with 0 issues, never seen any evidence at all to support the "fixes" people sell so figure if it's not broken don't fix it. GTE Pump has longer gears for more volume per revolution, in an NA consider it a High volume pump, none of the...
  16. I

    two left over plugs?

    Never seen any evidence of it in my engines Stom.
  17. I

    has anyone relocated their coil on a n/a

    Keep in mind that's a 7000 hardcut it's going to drop off a little below that point trying to catch it.
  18. I

    has anyone relocated their coil on a n/a

    Full Hardcut is around 7000, not so easy to get around on the Toyota ECU, in the past people have changed the clock crystal but I'm not keen on that idea as it changes EVERYTHING the ecu does not just the Limiter. There were a few daughter board setups back in the day but it required...
  19. I

    AFM... is this repairable with epoxy/JB Weld, or should I chunk it?

    My "concern" as always would be if it fails in the future during a power run, NOTHING kills a turbo engine faster than a lean out under power.
  20. I

    Very welcome Dude happy to help! :)

    Very welcome Dude happy to help! :)
    • IJ.
    • Profile post
View older results
Top Bottom