Search results

yea pretty much.

Ok so I don't mind thread jacking at all, lol. But this is just uncalled for.

ok true that, thanks. But I have decided to just leave it on. So no worries there. But with ARP's I torqued them to 85ft lbs. in sequence, thats correct, correct?

haha, dam.

So I believe I have been over stressing a bit about my motor. My main concern is the bottom end. I never heard it run out of the car it came out of, so it may be rod knocked for all I know. Also the head gasket, being only a OEM replacement, with ARP head studs, torqued to 85ft. lbs. But I have...

Ok thats all I need to hear, i'm probably going to go ahead and just get another OEM replacement from driftmotion.

Just a quick question about reusing a head gasket. It hasn't been started on, just torqued down to 85 ft. lbs, using ARP head studs. It is a composite oem replacement gasket, so the question is, is it ok to remove the head from the block after its been torqued down. Then reuse it once I have...

Just got this purrty little thang in the mail. But its not of use to me, cause I have no charcoal canister. So Ill probably just be capping these off. I'm still in need of some harness side water neck sensor connectors. Like the ECU temp. gauge, Dash gauge, Radiator cooling fan switch, AC...

Dam true that. Looks like your putting a lot of work into the tranny. I like it. lol. Hope everything turns out good.

Why not treat the stock internals, cause they are good for 450-500. And get a after market turbo.

You dont count.

Ok so I hit up the junk yard yesterday, and hit the jack pot. Found a car with probably 15 different connectors that were all the 4 plug like I was looking for and snagged 5 of them, just in case lol. So ill be rewiring those tomorrow. Pics will happen then :)

Sweet, I know what you mean with the wind. I live in FL. They aren't 50 miles an hour, but we have like 30 mile an hour gust off the gulf. And theres nothing stopping them. And I do all my work in a carport, so its like a tornado in there lol.

Sounds like a plan cause usualy I don't get charged for those things. So any 4 prong about 12 gauge wire is my next target at the junk yard lol

Thanks? I'm confused

The tranny looks like a R154 to me.

Dam true that.

+1 Goto Supra forums, then the venders section and look for elmest toyota. You are looking for a guy named Curt I beleive. Post a thread looking for a set of the 97-98 TT motor mounts. You have to saw off the little nubs they come with. But they are better and cheaper then the stock MK3...

+1 I knew that :) lol.

So thanks to this following link I can correctly hook up the sensors on the thermostat housing. And hook up there correct wires. http://www.supramania.com/forums/att...3&d=1155782183...