Ok guys I've run into another problem, the car won't start now. It's getting no spark, no power to the igniter and I'm not sure if it's related or not but I'm not getting power to the TPS either. I must have crossed and blown something while messing around with the igniter/noise filter. I've...
Anyone?
Here's the TL;DR of my last post
1) Does anyone have a list of ground points for the 1JZ engine and the MA70 chassis harness?
2)Is it possible to hookup the ignition noise filter without the female end? Could this be the culprit of my misfire, sputtering problem?
3) Why didn't my...
Ok guys I'm bumping this up because I am just now getting time to work on my car again and I'm still having this issue. Here are the things I have tried since I last posted ITT.
Gapped my plugs
Checked my wiring for the umpteenth time (for the record I did not extend my harness just reroute and...
After reading through this thread my guess is......................................Pistons hitting the spark plugs :)
Joking aside I hope they figure it out quick and it isn't anything too serious
Yup I pulled the blue boots off and no cracks their either. I don't know what the plugs are gapped to, I haven't changed them yet. I just pulled them to check and they are nearly new NGK iridiums. I'll check the gap asap
Hi guys,
My 1JZ is having the misfiring under boost problem. I've been searching and I've checked the usual culprits and I have some concerns
1) The cam/crank sensors resistance was in spec but both cam sensors had some oil in them.
2) 4/6 of my coil pack connectors were busted on the inside...
Thanks for the reply
Ground is good, I even cut the brown wire on the dash side of the plug and ran it straight to the body and still nothing.
I have the DM adapter and the stock 7M pressure sensor, I'll check the wiring for the M1 plug again tomorrow but I tripled checked it before installing...
Hi guys,
I am in the process of finishing my 1JZ swap, I have the engine in and running but my cluster is acting really weird and I'm having a few problems with it.
1) When I first started the car the tach worked but it was incorrect (showing idle at 200 when around 900 and showing 500 when...
Thank you, I'll get a better picture of #4, and #5 was given to me with the engine I couldn't find anything for it on the engine I think the seller just threw it in with the engine thinking that it belonged.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.