Search results

Grim's correct there will be a few mm of the polished seal surface visible. The pully goes hard up against the front of the crank so take a piece of alumnium or wood, put it against the front of the pully and give it a tap with a hammer to make sure it's seated.(make sure you aren't hitting...

I hope the thread starter only lubed the rubber lip of the seal...... I clean the case spotless then smear a thin coat of Permatex #3 on the outside of the seal, then a smear of moly lube on the rubber lip as it relies on it's sharp edge to function much like a Windscreen wiper (hence it's...

I thought the JIC's started at -5 degrees?

Defense: "I mistook his head for a Can your honour"

You're in trouble if your head is can shaped! ;) NWS

mmm baby cow was good <buRp> ;)

mmm baby cow :drool:

Change of plan just noticed the Pizza shop do Chicken or Veal parmigiana's now to decide ;)!

Mine was close but cleared, I'm running remote so it wouldn't have mattered.

Wow must be the offset my rears are 9" as well but stick out much more!

What size are the rears Jake?

Don't know if it's a good thing or bad but McMeat looks the same coming as going ;)!

I love my PWR :) (not to mention I had a little bit to do with getting them to fit our Mk3's correctly)

Lunchtime here just having Ham Cheese and pickle sandwiches. Might grab a pizza for dinner.

Jon: Not sure I still think it sounds AFM related

Here ya go!

It's NOT a new motor it's a USED motor......... Why not find out what's wrong with his first then decide if it's worth fixing as the JDM motor could have similar issues not too far down the track.

Possible, Do you have a friend with a known working AFM you could try?

Bit of a tip Jay take a single edge razor blade, scapel, new box cutter blade and run it round the edge of where you want to clean off. Doing this means it won't chip the paint and leave a ragged edge it'd be a shame to spoil that beautiful Red paint!

The relocation kit will still have an o-ring seal on the block boss Jay.