Search results

Ok looking at it from the back of the plug, mine are Left Right __________________ Red | Green/gray ------------------ Yellow | Black Not sure where your two yellows came from.

I'll have a look in a little bit

I would think you'd want the heat shields on if you do take it off, just my .02

That's hilarious but still :nono: heh

That's the way I was planning on going although I was still hoping to not have to do it. To me that's still hacking up my harness. Only way to go I guess though. I'll check out the liquid tape also Moe

I always wanted to try the Espirit Twin turbo V-8? That has my attention. Good luck with the smog.

I just didn't want to have to cut into my harness but I guess that's the best way.

Yea, should be 15mph and 25mph

I thought new cars were cleared for 5 years before they had to start getting smogged....

Dammit it all

I never found a replacement for that, I actually just cut that piece off and soldered a new wire onto the existing one. The clips should have a small hole in them somewhere to keep them from just popping out though. I think I put heat shrink or something similar over it to keep it from sliding...

Ok this is what I was told to use http://www.discountcarstereo.com/detail.aspx?ID=531 Will that corrode?

They might, I reused the old ones but getting new ones is probably better. I'd look around for a store that deals mainly in wiring and things like that but Napa or some others could have them.

You should be able to pop the wires back out of the plastic with a tiny screw driver and rewire each indiviual connection on the cps. That's what I did and it worked fine.

Hey would these work? http://www.radionics.ie/electronic-components-ie/index200.html Not sure if the link is working but they are called Electro-tap splices, will those do the same as he scotch locks?

If you're getting the rx-7 put a supra engine in it. Total sleeper

What did he torque the head to when it was installed? If you used a stock toyota gasket it shouldn't have blown after 10k unless you did something wrong.

Aren't the Clevite pistons ok to use?

Those all look like they're for domestics, and no 7m on the Toyota page that I saw.

I used to live in Baltimore when I was a kid so it was alittle more ghetto than redneck where I was :D