Search results

Maybe if you rounded out the runner inlets inside the manifold it would promote a smoother flow into each runner?

LOL, that's so like a squirrel. Them little bastards get all the way on the other side of the road, then when your heading towards them they turn compltely around and run right under your tire :3d_frown:. Or they will be right in the middle of the lane that your driving in and if they stay...

:werd: When I first set mine off, I didn't even know I had factory theft deterent! Then it took me FOREVER to figure out how to get the damn car to start after that. I think I ended up closing the door, locking it with the key, then unlocking it, and it started back up ;).

BLASPHEMY!!

I've heard that rotors that are drilled from blanks compromise the structural integrity of the rotor itself and can lead to cracked rotors. The only safe rotor to use that is drilled is one that was cast that way IMO. If it was my choice, I would buy ARZ's wilwood big brake kits, but if you...

Damn, that's an expensive clutch. Hey Jay, do you think you can have a clutch made for your car like the some of the guys from Louisville did? What did they call that place that made them... KY clutch? Is the pressure plate diferent on a 1JZ with an R154 or not? If not, I'd look at getting an...

Loss Mitigation Specialist.

93 octane here ;).

Two tone FTW! Actually I've got a grey supra with a maroon fuel door and a peal whit passenger side mirror... Three tone FTW!!11!

No problems, I have another job that can be switched back to full time ;).

Did you bust a nut on the swap Jay, or were you actually working ;).

Back when I used to work for my dad, I would get $1.00/hr raises, your damn right that I worked hard for those raises SC ;).

Oh, and when I got the email from my Vice president I wrote back: "Ouch, when you first told me raises around here weren't that good you weren't joking were you? The future looks dim in deed..." No surprise that I didn't get a reply back from that one eh? ;)

Funny thing is, the highest possible raise is a factor 5, or .25 IIRC. What does that say about the company?

My dad made some of those for his RV, some study Mofos them ramps are ;).

Chimp change ;).

Yeah, to your avatar :naughty: .

I refuse to have an avatar! Never really found one I liked.

Ha ha, that's too true. No one's perfect, I'm sure you've got a story or two to tell also JJ ;).

It's an ester based synthetic oil with a very thin weight at idle to prolong bearing life at startup (where the oil plays it's most important role, well, second most important ;)) and a decent add pack too. I also use 1 quart of RS530 racing oil (IIRC it's group IV) for the add pack in it also...