Search results

I don't think the weight distribution would be all that bad, you're not removing all that much Mass from the back of the car after you remodel it, move the battery down the back somewhere and it'd be fine. :)

Try giving the end of the pin a tap with something soft (wood or an aluminium bar) so it seats against the installed clip.

I like it! I would have bought the B Pillars further back to keep a more swoopy profile and not so much of a notchback but it's well done and runs unlike 90% of the cars here.

AU Falcon duals and trim the shroud.

Let her buy her own dress... what are you her Father?

LMAO maybe if was a rotary engine ;) The Pins I use have a chamfered end and that helps force the clips into their groove unlike flat ends which sometimes hammer the clips out.

I install mine so the open gap is just past the notch in the piston as this allows you to get a pick under the end of the wire so you can remove them ;) Can't see the orientation making a difference to them staying put.

I start one end where I want the gap to be then use a piece of aluminium to push it in starting at the end that's in already and working around.

Not to mention some are just full of shit....

They're a weird ass m9x1.25 or 1.00 can't remember which exactly. And one is unique as it's a shoulder bolt.

Looks fucking ridiculous... :nono: Shopping Trolly Handle.. bleah

WTF are you waffling about now... :nono: It's a closed system with a set volume of fluid, once bled tube/fin size has no bearing at all on the reservoir level...

Just screw all the stock Suppressors back in place and the noise should go away Brad ;)

Bang 49cc into the calculator and see what it says.

Pistons in a 7M are 20 thou out of the holes at TDC, from memory CC volume is 49cc but it's been awhile since I was hands on with one. You'll have to listen carefully for any sign of detonation and maybe pull some base timing out of it if you hear some.

Next Friday when it comes back from the Coaters :p

Any fuel/oil resistant hose will work, the Cooler circuit is in the return so is low pressure

The exhaust is off being Ceramic coated I'll ask the owner if it's ok to post some pics, car is here up on my lift ;)

Built a right side header for a 1UZ swap into an 1984 MX63 Wagon yesterday ;)

Andy you'd bang a hole in a fence of a wedge of swiss cheese... :)