Or you could purchase factory black leather seats. Hard to find anyone willing to sell theirs, and even harder to find them in good condition. I was able to find both.
If you read my post, you would have read where i asked if anyone knew for sure if it would cause the code.
BTW, thanks for the useful information cuel.
I bypassed the n.s.s because i couldnt get the car to start and traced it down to the n.s.s. I tried adjusting it per the trsm and it still didnt work. Bypassed it and it fired right up. I thought maybe the code 43 is due to that, but im still not sure. Does anyone know for sure whether or not...
I bypassed the neutral safety switch, i dont think that has anything to do with the security system. Other than that, i have not bypassed the security system.
finally got time to work on the car a little bit. Checked the timing according to the trsm and its right on. I checked for codes and it threw a code 43. Start Signal
Diagnosis
* No "STA" signal to ECU until engine speed reaches 800RPM with vehicle not moving.
Trouble Area...
The timing is fine. I have driven the car several times before and it ran great. I doubt replacing the dead battery with a good battery disturbed the timing...
I took the battery in to get it tested and it was shot. I got a new battery and put it in and it started up. Now it idles really high and revs on it own. It revs from 1500-1900 rpms. I let it run for several minutes thinking maybe it would stop, but i wasnt that lucky...:nono: Any ideas as to...
I figured the title would get more people to look at it lol. The alarm is not set, i checked that. I bought the car and it was not running and had problems getting it started when i got it. I am still trying to get the bugs worked out of it. I checked the wire going to the starter, its fine. I...
It doesn't like to start. At first, the battery seemed to drain overnight and i have to jump it to start it. I would get in the car and no lights would light up on the dash, nothing. iv replaced the new battery with another new battery and it did the same thing. So, i replaced that battery with...
i was looking at buying some arp head studs and saw they have u cut studs and regular studs. What is the purpose of having an undercut stud? Which type should i get?
Has the battery died/been taken out recently? If this is the case, it needs to relearn idle and you will need to give it a little bit of gas to keep it from dying and the RPMs will go up and down while its doing this.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.