Not too bad from what I can see. Charge his insurance provider for a band new rear bumper and reinforcement from Toyota and then just source a good used one from another car. Might make a few bucks.
I also say to run it as a stocker and sell everything else off until you can swing the cheese again.
Next time I come down to PCB I'll have to pm you. Maybe get your number.
A few of my friends work and a bar down there and I should be going down to work a couple times this summer.
The little tabs broke off of my stock sills but I just used another similar little plastic, square thing that the screw expands. Don't know what they're called. You can get a box of them at any auto parts store.
Oh I thought I read on the last page that he could make them for $65 a set. Which would be a crazy low price..
Unfortunately both of my pillar louvers have cracks. :(
Lol..
I watched someone do that in the shop when I went to auto- tech school..
Guy really thought we were yanking his chain when we were saying he didn't put the drain plug in..
Where is it leaking from? Front seal? Side shaft seals? Oil drain? Where the 2 halves meet? You can just replace seals instead of getting a rebuild if it still works fine.
I have a question. This is the Alt. that came with my JDM motor. What is the thing attached to the post? Only thing I can think is a capacitor of some sort to reduce interference?
Yeap. I thought it was actually pretty good.
Of course when we got out there was a ricer fest going on in the parking lot.. People doing burnouts and revving their engines...
I did see two groups of people stop and check out my Supra in the parking lot tho..haha!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.