Found someone selling a turbnetics turbo:
t3/t4 turbonetics 57 trim.
2 3/4" inch inlet
stage III .63 a/r exhaust
$600
minimal to no shaft play and only couple thousand miles.
Good deal? yay or nay? I dont know much about turbo a/r. What kind of spool should I see? Is it too big?
Trying to swap out transmissions on my supra, w58. I got the trans to slide back 3/4 inch and it wont come off. It seems to me like the pilot bearing came out of the crank and is stuck on the trans shaft and wont come past the clutch? Anyone run into something like this? Please post up ASAP im...
I am going to get a MAFTpro and I am trying to do some research before I buy what I need however I cant find an answer to my question. I will be using the boost control function so I found this gauge http://www.aempower.com/ViewCategory.aspx?CategoryID=73
It has a 0-5v output. Would I be able...
My CT26 has a crack in the turbine housing between the wastegate port and turbine that I noticed, what kind of problems would come from this and would the turbo need to be rebalanced if I replace it? I have a spare CT26 that I disected since it was siezed and came with my JDM engine. Ive tried...
My CT26 has a crack in the turbine housing that I noticed, what kind of problems would come from this and would the turbo need to be rebalanced if I replace it? I have a spare CT26 that I disected since it was siezed and came with my JDM engine. Ive tried searching for info on this but came up...
I have done some searching with no progress. I need a GTE AFM. I was wondering if a 1UZFE AFM will work with the GTE. I noticed on the wiring diagrams that they are wired the same exept the E1 is grounded through the ECM on the GTE and on the Lex its just grounded. Can it work? It would be so...
Where do I get the pickup coils for the CPS? Is there a source to get them? I am in need of them but I think its a waste to have to buy a complete CPS when the only part bad on it is the pickup coils... There has to be a place that has them since you can get a reman unit.
I am having trouble getting my supra started after GTE swap. I just checked the CPS pickup coils and all 3 have 215-220 ohms. The spec is 140-180 ohms, is that a direction that I really should be heading in?
has anyone noticed that this scematic in the TSRM has typos or am I reading it wrong?http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=D&P=34
The ECU to ignitor circuits seem to be mixed up.
IGT goes to IGDB
IGF goes to IGDA
IGDA goes to IGF
IGDB goes to IGT
I have a 87 supra without ABS that I am rebuilding and seems like the brake master cyl. is blown. My question is will a master cylinder from a 87 supra with ABS work? They both have the same dimensions and same 2 outlet ports and will bolt right up, but they look different. I dont know if they...
Im nearing completion of a NA-T conversion and I dont know where the 3 HAC sensor wires go. Can anyone find me a picture of the HAC sensor connector so that I know wich terminals the HAC sensor wires plug into. Thanks.
Anyone running this exhaust? I have never heard of it so it must not be very popular? I like it because it comes with a dual exhaust tip. anyone have some input?
http://www.horsepowerfreaks.com/partdetails/HKS/Exhaust/Exhaust_Systems/Turbo/1232
I am in the middle of a 7mgte swap and I rewired the ge harness to work with the gte. I have everything squared away except for one circuit. Im not sure what the TIL (Turbo Indicator Light) pin on the ecu is really for. anyone have any insight on this? the ecu is a 87 I believe.
I am currently swaping in a JDM 7mgte into a 87 supra NA. The gte came with a harness and no ecu. The car had a blown engine and the old owner gathered a gte ecu to do a gte swap but never got it done.
My question is the harness that came with the JDM gte engine has different ecu connectors...
HI. This is my first post on this forum.
After wanting to get a supra for quite some time I came across 2 different supras really cheap
87 Targa N/A 5speed Maroon exterior/Maroon interior
*Free*
Car is pretty rough and has been sitting for 5 years under a car port
Engine is out and the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.