Please RSVP here:
http://www.supraforums.com/forum/showthread.php?t=586522
Hey Everyone,
A few of my buddies and I are looking to dyno our cars this weekend. I called around and got quotes from different places such as Kito and CarbConn. Kito seemed super busy, and CarbConn was a little...
Just cuz your pully is wobbly doesnt mean your pump is bad. might just have a bent pully. but eventually it will go out cuz there is a large chance that your WP took a beating since the fan is its only front end protection during shipment.
It depends on your setup. you running a mechanical fan...
Caps were replaced, but still no good. I tried my ECU today on another car and It IS DEAD... Trying a new ECU TMRW!!!
my IGSwitch wire was disconnected so I'm guessing it ran for a while then finally fried the ECU.
Anyone know what the water temp sensor resistance supposed to be on the 1JZ? cold? warm?
I need the one on the water neck - green with a two prong receptacle.
Thanks!
I ran into the same problem last week. Ran like a dream, then overnight I went to start it and It just ran like Crap.
Really rough idle, sounds like its mis-firing, Runs REALLY RICH... Dies on its own on idle, Cant get it to rev past 2k, even getting it to 2k takes some effort.
I pulled...
Just to add on:
for your tach, you mentioned having an N/A body. So I'm guessing you are using the same N/A Gauge Cluster.
You should still hook up the Tach Signal to your M1 plug, but the N/A Cluster still wont work.
7mge used a distributor to get a tach reading, where a 7mgte or...
Not too sure, what is your gap set at? always good to double check. Could be a variety of conditions. My car was fine at ~12 psi. when it was cold i would hit 13-14. this is when my plugs blew out. iono. doesnt hurt to double check the gap.
It's doing great, the chatter is not too bad, I'd imagine it being worse with a High pressure plate. but the stock one is holding up just fine, Its almost like an on/off switch, but takes getting used to. No slipping yet.. :icon_razz
thanks!
Ya, The MK2 is running great. I did find the...
Sounds great, wish it was closer. maybe I could get a few people up there for an event to help out. When are your events? whats the cost? how many pulls? baseline? What kind of dyno is it?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.