well once again i would like to thank everyone who answered my tuning/install questions....it was a big help not going to the dyno without any knowledge.
As for the results...
Run temp....90 degrees
12% humidity
first pull--baseline (8psi)----225hp 226torque
running very lean so we start adjusting
tuned---(8psi)------239 hp..243.45 torque
11.18 (a/f)
****note for tuned low boost pull***** after we did this final pull on low boost we realized that we left the safcII tuned for high boost....so we figure that the a/f was better and a little higher horsepower if we switched back. However we already got the car off the dyno.
tuned (12.5 psi)........275 hp.....295 torque
11.54 a/f ratio
All in all I am pleased....I figure an intercooler and pipes will help out alot and maybe get me closer to 290hp. Also we tried to tune to 13 or 14 psi...but the turbo said no...it would just drop back down to 12ish. So we tuned at that level.
Mod list: K&n intake, MAFT, 3inch exhaust turbo back, high flow cat, greddy profec A, SAFCII, plugs and wires
When i return to school sunday, i have 3 videos and 2 dyno graphs and ill post them up
As for the results...
Run temp....90 degrees
12% humidity
first pull--baseline (8psi)----225hp 226torque
running very lean so we start adjusting
tuned---(8psi)------239 hp..243.45 torque
11.18 (a/f)
****note for tuned low boost pull***** after we did this final pull on low boost we realized that we left the safcII tuned for high boost....so we figure that the a/f was better and a little higher horsepower if we switched back. However we already got the car off the dyno.
tuned (12.5 psi)........275 hp.....295 torque
11.54 a/f ratio
All in all I am pleased....I figure an intercooler and pipes will help out alot and maybe get me closer to 290hp. Also we tried to tune to 13 or 14 psi...but the turbo said no...it would just drop back down to 12ish. So we tuned at that level.
Mod list: K&n intake, MAFT, 3inch exhaust turbo back, high flow cat, greddy profec A, SAFCII, plugs and wires
When i return to school sunday, i have 3 videos and 2 dyno graphs and ill post them up
Last edited: