I'm down to prepping the deck of the block. I'm going to install an HKS MHG. Are there any recommendations on how to prepare the block.
How should I get the old gasket off the block?
Should I scrape off the big chunks of old gasket and then use a die grinder with surface preperation discs? Ultra Fine of course.
When installing the MHG, should I use copper spray to fill the slight divits in the block?
Or...should I just take it to a machine shop to have the deck re-surfaced?
Not necessarily looking for the right or wrong answer, just suggestions and experiences you may want to share.
Thanks,
-Kenny
How should I get the old gasket off the block?
Should I scrape off the big chunks of old gasket and then use a die grinder with surface preperation discs? Ultra Fine of course.
When installing the MHG, should I use copper spray to fill the slight divits in the block?
Or...should I just take it to a machine shop to have the deck re-surfaced?
Not necessarily looking for the right or wrong answer, just suggestions and experiences you may want to share.
Thanks,
-Kenny