GC89;2070025 said:
Nice work, after completely rewiring a few factory harnesses I have always thought building one from scratch would be much more enjoyable. Jealous of how much progress you make, I have too many other projects.....
with the amount of time spent on it, i will probably have one made next time. its a good feeling have tackled a big job like this, but i think once is enough for me haha.
the rest of my nylon sleeving should be here on Monday, i thought i ordered the high head/flame resistant wrap but instead got the standard wrap. oh well, its not too expensive anyway.
also polished up my fuel rail a little bit, much better than the crusty old piece.
next on the list after getting the harness wrapped up is to get the new catch can setup.
im looking into this catch can, its baffled with dual 12AN ports. 1/2NPT to 3/4 barb fitting will be threaded into the valve covers, i dont want to weld them on since they were just recently powder coated...
since im going to be running more boost, i figure i should upgrade my PCV system too
didnt note it before, but one of my favorite recent parts is the old school toyota logo oil fill cap. i took it off an old 20R toyota pickup engine i had laying in a parts box, i think it fits in perfect