Project "Big Nasty"

[Ymh]

I have a 89 turbo that i bought a few years back for $200. After tons of hard work and reading its about ready to get back on the road, but i need some help. Am at the point now where am noticing parts that are missing before i bought it. Some also the a hack and slash job on alot of wires.

the engine when i got the car.

the engine before i put it in the car.

i have more pictures to come but i have some questions
I thank everyone for their help!!

Heres a plug that on the transmission, what are the wire colors of the plug that goes in it?

Heres the CPS that shows some of the hack job some1 did to the wire harness. i need to know which wires go together.

Heres the water pipes on the side of the block. Where do they hook up to? i think one was even capped off when i got the car.

 

[s383mmber1]

I can help you with the CPS wires. Give me a few moments to go take some pictures downstairs.

 

[Ymh]

ight sounds good

 

[92nsx]

#2 on the water/coolant pipe get pluged, and #1 goes to the heater valve on the fire wall.

Also the plug on the transmission I believe is for the back up lights. Is the wiring Long or short (if theres 2 coming out of the tranny, mine dose.) The long one (from the tranny gets ran up to the main wire harness under the hood and connects to a plug around the rear knock sensor and starter area. If there is a short harness on the top of the tranny, there is a long plug coming off the main harness under the hood that that one connects to. Kind of a pain to plug in because the plugs are on the top of the tranny, and only room for one hand. But all of this is on a manual tranny, I dont know if U have a manual or auto.

hope this help.

 

[Ymh]

Anyone can help me on the CPS wiring?