Please help boost controller install

[huntin5L]

Hey guys need some help quick. Is the 7mgte motors internally wastegated or does it have an external wastegate.
Also, where is the fuel pressure regulator located, i need to be certain and a pic would help. Also, If it is internally wastegated where does the hose hook up to from the solenoid. Thanks guys im in the process of installing this.

 

[rpk2012]

Wrong section bro. :sleep: :wave:

BTW - Stock setup, the W/G is internal. The actuator is external and you can hook up your controller to that vac line that goes to the actuator. The FPR is located at the front of the fuel rail. (Correct me if I am wrong guys!)

 

[silver88turbo]

Thats right buy why do you want to know where the fpr is for a EBC install?

 

[huntin5L]

sorry mods please move thread...

Where do you mount the selonoid from the boost controller and where is a good place to feed the vacuum line and wires through the firewall

 

[huntin5L]

It says you have to t off the vacuum line going to the FPR

 

[silver88turbo]

hmmm.....

I would tee off of the rear most of the two hoses coming off right behind the throttle body.

 

[huntin5L]

Where is a good place to feed the wires and lines through the firewall?

 

[aye mate]

under the clutch master cyl.

 

[huntin5L]

hmmm..checked there didn't see anything but an opening to the fender...Nothing under the clutch master cylinder

 

[Justin]

ou have to drill a hole, its a very good place to do so.

there, or thru the main ECU grommet


I'm going to be installnig my e01 and will be doing a great write up on it... i know you don't wanna wait but...

 

[CassMori]

thru the main ECU grommet

:withstupi

 

[huntin5L]

Where is the ecu...and where is this so called grommit lol

 

[CassMori]

Where is the ecu...and where is this so called grommit lol

the ECU is behind the glove box.....the grommet should be just below the hoses & valve for the heater, on the pass. side of the firewall. I'm not at home, or I'd post a pic up....