do i need to clean in between layers or just spray copper spray in between layers. or just leave it alone. i have already cleaned the surface to the metal just want to know if this is all i have to do.
metal hg reuse question
- Thread starter Supraboy89
- Start date
IJ.;1086961 said:
so do i need to seperate the layers by removing the rivots or just pull it open a little and spray it with some carb cleaner
Nope
Use the head studs as guides and install 1 layer at a time being careful to line it up on the dowels before sliding the next layer down.
You get 1 chance to get this step right or you'll be stripping them again as they'll stick instantly to each other.
Use the head studs as guides and install 1 layer at a time being careful to line it up on the dowels before sliding the next layer down.
You get 1 chance to get this step right or you'll be stripping them again as they'll stick instantly to each other.