HPF feramic clutch disc

[blackout_89t]

Anyone use this disc?

http://www.horsepowerfreaks.com/pri...h_Disks/part/Feramic_6_puck_-_Supra_MK3_Turbo


Looking for some more opinions on this disc.

Street/drag car.

Thanks.

 

[GrimJack]

Not quite - I use the full face version of that disc, though, and I'm happy with it so far. Makes some odd squealing noises when it's cold, but it holds fine.

 

[blackout_89t]

The full face was what I was looking into before, but now I can't seem to find it on their site...

 

[oscolivar1]

Don't use an aluminum flywheel becuase once the feramic disk gets hot it will wled itself to the flywheel. Just use your Stock flywheel(resurface it).

 

[lintlars]

Yes beware of the fullface feramic when using a AL FW I had one weld on me I am now using the 6 puck version with a stock FW great clutch and very streetable.

 

[drjonez]

i have the 6 puck version w/a ACT PP and the RPS FW. @ the time HPF said the only Al FW they would support w/the feramic was the RPS....and i think they have changed that claim now.

as far as feel, the disc is fantastic. no chatter, etc.....just a very short engagement. much better than any other ceramic or sintered iron disc that i've used.

however, i'm not convinced it will hold any real power. when i had the car apart (ha, the past 1.5 yrs...), the PP and FW showed signs of A LOT of heat....moreso than i would expect for the 2k miles i had on the setup (and most of that wasn't hard @ all...). we'll see what happens when the car is back on the road this yr....

 

[blackout_89t]

Great info!

Thanks!