CPS install

[Nomad707]

Ok.. i've done this before a while back but i want to be sure im doing this right.

Is this adjusted right? i just insert it into the head like it is right now, right? and it has to stay at 1 oclock aligned like this picture shows?

Thanks.

Edit:
its supposed to be set like this when the engine is TDC along with the cams at TDC??????
i have the tsrm but its not very clear to me.

So this would mean that my engine is 0 degrees TDC? And its good to try and start?

 

[shaeff]

http://www.supramania.com/forums/showthread.php?t=38775&highlight=CPS

-shaeff

 

[Nomad707]

t/y sir.

 

[shaeff]

it looks like you might be one tooth off. i have always lined mine up like i show in the link, and always get the timing dead on with no problems.

is your pic taken at an odd angle or something? it threw me off at first.

-shaeff

 

[Nomad707]

im holding the cps by where the bolt goes to adjust it up and down.. if the cps were pointed up i have the tooth to 1 o'clock

edit: yes i took the pic at a slight angle

 

[3p141592654]

Align the drilled hole in the gear with the groove on the housing.

http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=IG&P=24