Search results

It's a standard JDM A70 part, uses the regular plate tow hook bolt and the bumper support bolt to hold it in place.

Nice work!

Just made this and uploaded for you, enjoy. http://www.thingiverse.com/thing:1830309

http://page3.auctions.yahoo.co.jp/jp/auction/c567762167

Pictures? Those side skirts should be fairly thin so as to just barely squeeze between the door jam and rocker without rubbing.

Have you checked the spare tire area, inner wheel wells, and body rear side pockets for rust as well?

Cool! Too bad I clicked hoping to put my ME degree to use. :biglaugh:

IIRC I came across a picture or two of it in a parking lot 4-5 years back, but that could be my old age playing tricks on me now... We were teenagers back then!:aigo:

The 7M fan clutch fits just fine, as well as most other Toyota models IIRC.

Of coarse it can, I used to run the same setup. If it's a 3rd gen engine/ECU you'll want a TV04 and TP15 patch harnesses, or you can hard wire it if you wish. They aren't difficult to find considering these are 20+ year old electronics, you just have to know where to look. Edit: Also running a...

Looks like an improvement over most of the beaters I see.

If you ask they will usually send you a sample square of each before purchasing. Also just an FYI for anyone looking to purchase ACC. Mine held up great, but be prepared to spend quite some time trimming and fitting to get it looking OEM, unless they have better molds now.

3rd gen uses high impedance 315cc injectors, should be lime green. You can get these from most 7m-ge. 1st or 2nd gen 1G however will be another story.

I believe dual thickness refers to a gap between the inner and outer sheet metal such as the 4th gen firebird/camaro, this will cause a problem when trying to roll flat. How much work you will have to do on the A70 will depend on ride height and how aggressive your wheels are. I had to roll...

The smoked plastic hatch visor? It can not be repaired with fiberglass.

No one has inquired about sending payment or group deposits, so no molds will be made.

I've made hundreds of these in carbon fiber for the H22, all you have to do is ask.

I wonder if that is the same STS I imported and sold around 10 years ago.

I bought mine straight from Toyota, just took a few minutes in the TSRM.

Interesting, so Sarona made a replica of the Erebuni sides and rear as well:icon_conf Learn something new everyday.