Search results

I have my custom double pole, single throw switch so that one side is low blower speed and the other is high. It was working fine but when I was going to put in a nice switch today, only low works. Before when I would ground the different blower speed wires, there'd be a click noise coming from...

i recently did a partial rebuild of my 7mge and got really terrible HCs in my emissions testing (320-360). before the rebuild, the car got more like 200-300 depending on the day. previously the car burned oil like crazy, so i had always blamed that for throwing off my fuel injection system. i...

this green connector is between the starter and vsv/vacuum tank. any help? http://i.imgur.com/DSi8ceY.jpg

is it safe to leave the heater relay jumped at all times? this is what im doing: i have a custom switch for off, med, and hi blower speeds. im using an on-off-on switch, so the relay is constantly grounded, while one on position is hi and the other on position is med. so, the relay is always...

just got done rebuilding engine, and as a sanity check, want to know what that first dash in the stock oil pressure gauge means. about halfway up the gauge there is a tick for 40, and below that, im assuming 20? the gauge isnt linear and im not sure why they omitted the reading for the first...

could anyone tell me what part this is and where it goes? thank you! http://imgur.com/WnbzEMA,r5V1qFn#0 http://imgur.com/WnbzEMA,r5V1qFn#1

are there any more detailed diagrams of all the vacuum lines? i have the diagram from the parts book, but id like something even more detailed than that. for instance, there are two vacuum lines that come off the power steering pump and im not sure where one of them (the one further to the...

Some rust has worked its way up the fuel line. Apparently the guy who cleaned my injectors said it was just a bit and the injectors are okay, but I should replace the fuel filter. Of course, that is easier said than done on the Supra, but I'd like to take a look at it anyway. My question is...

My speedometer cable seems to be a bit noisy and jumpy at the gauge connector. I'm not positive it is that connector, but it used to be a lot worse until I was able to plug it in better at the dash, so I assume that was the only problem. The thing is, it's still a bit inconsistent and a bit...

I would like to remove my heater control panel (the thing that controls the HVAC system position, blower speed, etc.) but I can't make sense of the harness. I would ideally like to have a multistage switch that I hook up the ground and it simply connects different pins to control the blower...