I have a Koni Electric Supension(tems)+koni controler
I have a koni supension controller that i can set in 4 steps to different levels off hardness.
I can control the front and and back schokabsorbers butt i have only the back schokabsorbers.
Does anyone now where i can find more info...
WILL THE STOCK FEULPUMP FROM A 7MGTE ON A 1JZ BE ENOUGH?? PROBLEM???
I have a problem.
I have build a 1jz in a supra mkiii whith a auto tranny.
I am using a suprastick manual on the steeringwheel so i can shift when i want.
Butt it will not run further then 4000RPM.enigne stumbels around...
update info
i now what the problem is now.
i need advise about how to solve it.
the problem:
i used the old autotrans ECT ecu i did not wire the L1 L2 and L3 wire's.
normally they go to the ecu.butt the soarer ecu has a different signal.
how can i solve this problem???
check this...
build 1jz+autotrans in a mk3 problem goes no higher then 3000rpm??
i have build a 1jzgte whith auto trans in my mk3 supra butt the trans shifts up by about 2500/3000rpm.
what can be the problem???
throttle valve?
i installed the autotrans cable to Toyota specs.
need some help please.:1zhelp:
thanx for the info.
1j bell house will directly fit.great!
butt i also heard that a 3j bell house will work whith some modification.
butt i will use the one from the soarer then.
auto tranny from a supra/soarer on a 1jz what parts do i need for it???info...:1zhelp:
I want to use a auto tranny on a 1jz.
I have one auto tranny from a 7MGTE and also i have the one from the soarer 1jzgte.
Wich one is the best option to use?
I geuss the one from the 7MGTE type 30-40LE...
First of all
i have been trying to get the car running and i just built this engine together.
i have a lot mods:
Motorswap 1JZGTE twin turbo
Upgraded 1JZ twins(from Albert)
Inconel shaft & Genuine GT2860RS 62trim Compressor wheels
Standaard 39mm in/58mm uit NU Garrett 47.2mm in/60 uit...
yes it don't usses the hole rotor.
butt the brake disc is a lot thicker 6mm (more cooling so less chance of fading ) and the caliper has 4 pistons.
i did not test the brake distins before and after sorry.butt i can tell it brake's much better and i have the same tire's and rims as before.
result:
this front brake upgrade you can use the sawblades butt only whith longer 45mm wheelstuds and 20mm wheelspacers .
update info
you need
junior brembo's
brackets
you need hub rings 1mm
i needed spacers and longer wheelstuds becuase off the rims ET.
normally i think not neeeded...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.