Search results

I know they make a tranny cooler flush in a can. Knocked alot of crap out of my Trooper's cooler.

I think its cylinder head supply.

Gee, you're absolutely right. You did say that. Sadly, i had misread what you wrote, and thought it was already in the groupbuy section. ...but it's not... ......hence, my sadness....When i get sad, my Alzheimer's acts up... Say- is this gonna be in the group buy section?

Ok, 18 posts later, you decide to mention that you have a completely custom clutch system that's been designed to work as a push-type?? lmao.

So, are you going to place a thread in the group buy section?

Yes i saw. Very nice. There's light at the end of your tunnel.

I would be interested.

What spacer? I wonder if you have the clutch disc possibly in backwards.

1/2 height.

did you take any pics prior to putting the head on?

Finally got around to getting a pic of my mod to the pivot arms. You can see where I cut the arm about 3/4 of an inch shorter, and relacated the ball, by knocking it out(press fit), drilling the same size hole, and drilling/tapping the backside of the ball for a small screw. In retrospect...

I'm guessing that 12-14ga. wire would suffice.

i assume the 2j's use them as well

Well, I got bad shudder with an aluminum flywheel and a 6-puck. So I definitely want a fullface disk this time.

Bling bling... ps- Never thought about relocating the charcoal can to the rear of the car...kinda makes sense.

Thanks, Bog- it did come out as I had envisioned it.

Looking forward to the final paint!

Thanks for reading, Ev! Had a little bit of a scare tonight... Was hunting around Driftmotion.com's website for a few things I need, and saw that they sell dowel pins for aligning the head to the block... HOLY CRAPBALLS!!! DOWEL PINS FOR THE HEAD!!! Did I install them? I can't remember... Are...

So today was just a little bit of fiddling around with little stuff, and taking note of what gaskets/ fasteners I still need. When I pulled the old motor, I dumped alot of tranny fluid on the floor, and though the kitty litter soaked it up, I was getting tired of the stank, so it was time to...

Hoses look good. I'm in the process of installing mine as well. Mine are the generic Ebay silicone full-engine set that a number of people on here have picked up. So far, they seem to fit nice and tight, and are shaped properly to replace the originals.