Search results

To answer your question about the injectors- they could be 680's. Denso made some that are yellow top. I just bought a set not long ago. I don't know what car ever ran them, but they were original equipment in a number of Arctic cat and Fire cat snowmobiles. Part number on the side (in very...

It may be a Nur-Spec exhaust. The connecting flange by the diff looks correct. Me, I'd stick with the 7M. If you go the JZ NA-T swap route, you can expect it to take ALOT longer, and require alot of fabbing. I'm sticking with 7M, and I already haven't driven my car in over a year and a half!

I read that the turbo outlet flange tends to be deformed during the welding process, and it causes it to have gaps. The solution was to have it resurfaced. I would expect that if you had the face of the flange resurfaced slightly, and so that it angled towards the outside edge(side facing the...

Dunno if its the same as denso(stock injectors are denso), But grab some EV1 connectors for Evo injectors.

Have all-new expansion valve, drier, evap core, and discharge and suction lines, but need the condenser. Mind if i ask where and how much, Doat?

Does this help?

Hmm. Lemme go look in the garage...

I would guess....post a wtb thread in the wtb section?

And they may or may not be testing it on Elvis' car...

Its a bit rough around the edges still, but there's also alot of win hidden in that car. Blitz IC, and looks like Tien coilovers, and not sure what exhaust that is.

Looking nice.

Yes, the fork is held in by a spring clip. Should be mounted already inside the bellhousing.

All thats left of the old setup is the shortblock. I will sell it eventually.

Hmm. Been awhile. Haven't done much, because I was out of town for the past ten days. Today I finally put my old engine on the second engine stand, and ordered a few necessities, like coolant pipe gasket, ISCV seal/bushing, and chromoly flywheel and Spec 2+ clutch. The tranny work will be...

Progress is progress. :)

Looking very nice.

What type of paint did you use?

The hks doesn't include a turbo elbow. If you dont already have an aftermarket elbow, you'll need to either get one, or get a downpipe that has one built in.

Or, he may be parting out, and is just accepting the w58 setup to make the transaction happen, and will turn around and sell that stuff as well to get more $$.

Good. The can that i refer to IS pressurized. You spray it into one line, and crap runs out the other, into a waste container.