Search results

  1. I

    Removing the last wire from the harness to the tranny (86.5)

    The little tab pulls up to release.
  2. I

    What could it be?

    Are the Tabs still there?
  3. I

    What could it be?

    Any marks on the backside of the bearings?
  4. I

    80's music vids!

    Just in case I think my +1 will counteract any - ;)
  5. I

    What could it be?

    13: It's detonation damage! aka: Hammered bearings :( Time for a new set and make sure you check the ringlands as they will have suffered!
  6. I

    need advice on cams for 89 turbo auto

    Hard to tell without a "@ .050" lift" figure.
  7. I

    need advice on cams for 89 turbo auto

    JCF: As I said the NA is cheapNeasy so why not give it a try get some before and after numbers then if you want more then go bigger?
  8. I

    What could it be?

    13: Do the rod bearings snap into the rod and not fall out if you shake it?
  9. I

    7mgte head problems

    Measure it and post...
  10. I

    need advice on cams for 89 turbo auto

    Doward: Thanks! JCF: Always question! Post count means nothing ;) If you're not doing anything to raise the rpm limit the NA Intake will help out a bit midrange and you need to ask yourself honestly "how do I drive my car" If you're at redline a lot, better cams will help! The specs I'm...
  11. I

    *Yokohama 048 Tires*

    Aaron: LMAO Pumpkins would grip better than what I have now :)!
  12. I

    I think white smoke was oil shooting out my dipstick holder (with video)

    Any PCV system mods done? DAMN .025"??
  13. I

    *Yokohama 048 Tires*

    Clifton: The Yoko's are only available in MH in the size I want but I'm not sure what durometer this equates to! I guess being a big heavy powerful car it would tear up softs pretty quickly.
  14. I

    need advice on cams for 89 turbo auto

    JCF: CheapNeasy I'd swap in an NA Intake cam and see how that works for you as your motor is lightly modded.
  15. I

    AR5 Trans Take Two: The Solstice Solution

    My TKO has a .68 5th and even with 4.10 diff gears is quite tall.
  16. I

    Kyle's World!

    Guilty as charged your Honour ;)
  17. I

    need advice on cams for 89 turbo auto

    The Motor is a system and needs to be built as such or you end up with an imbalanced PoS.... I chose my Cams based on 30 years of playing with motors but have to admit that in the end I still wasn't sure how the 7M would respond but I'm very happy with the outcome! Anyone that tells you...
  18. I

    Girls get kills too...

    :ttiwwp:
  19. I

    Thinking about investing in some tools.

    Good tools will be with you for life :) mmm tools agllllhhhhhh <Homer drool>
  20. I

    need advice on cams for 89 turbo auto

    I run these and they make good power to 8000 but the turbo I'm using runs out of breath on a 3.0 once you get to around the 28 psi mark and 7500. In hindsight I should have gone for a little more life and duration but as this was the first time I've cammed a 7M I went a little conservative...
Top Bottom