Search results

That cheap shit isnt worth mounting. You can stop better using the soles of your feet like the flintstones.:aigo: :biglaugh:

Autozone has the one with ceramic in it. Its good up to 2000 degrees I think, but I am not to sure; However I use it on my turbine housing and down pipe and it holds up great. You must bake it on the turbine housing. The down pipe I couldnt get into the oven So I let it dry, and then just...

I installed dual walbros, and my custom fuel rail finally. This is the final leg before installing my standalone. Finally my wait for LS-2coil plug ends is over and I am ready to proceed. The only thing holding me back now is the installer...

They are very good pistons!

Today I just installed my custom dual feed fuel rail with the return in the middle next to the cold start injector feed. I put 2 walbro fuel pumps in the tank with custom braided hose. The tank assembly was reconfigured with aluminum -6 fittings and all the original oem feeds were removed. I ran...

Ron Rimirez type gauge. there are companies that sell them separately.

Get rid of the stock screws and use hex bolts and lock washers and never look back, and never see a leak again. Doing this with new gaskets is more apealling though.

thats all you need to know

Thanks Pics of new GT4067R, and CSF radiator to follow. I will be upgrading the fuel sysytem in the next week. I have one walbro fuel pump, and will be installing 2 in the tank. I had the stock fuel rail bored in the middle for the return line, and will use the ends as dual -6 feeds...

http://www.cardomain.com/ride/571789 my beginning before going FFI http://www.cardomain.com/ride/571789/12 my engine on stand .040 over bore with the largest intake on a 7m of 3 litres http://www.cardomain.com/ride/571789/13 Stock TPS on Q45 TB...

[/B] That is correct

Sounds suspect tome! Make them pay

You won't need a small hot side for a GT4082. It will definitely give you close to 500 hp and spool nicely I think My 7m spooled it fully by 3800rpms @20psi.

I just sold my house in Mastic, looking for a new one. If I didnt have my boyz(divorced) I'd move south. I have meets on the regular and am still on LI.

Who has the size of the banjo bolt fitting of the water return line on the bottom of the water jacket to the turbo. thanks

Nice to see ya lifiting off

Good info I have been looking for these for months.Titanhas them for 5.00less!

Damn that thing sounds nice. Awesome job Duane

I would have prolly done a low 12 or high 11 if I didnt get locked out of second and third gears while shifting. I coasted 2x while shifting into 2nd and 3rd gears and still did a13.8. My crank pully kept coming lose so I didnt make more than 1 pass so to be on the safe side I stopped dragging.