Search results

  1. hvyman

    Thread pitch of hub threads

    Wheel studs? 12x1.5 if so.
  2. hvyman

    Standard timing belt, or high performance belt?

    No sticker :(
  3. hvyman

    driver side upper control arm bolt bent

    Yup :)
  4. hvyman

    Project Git 'er done!: Stages 1, 2, 3, 4....Stage 5- Reassembly after 13 years!!!

    Oh lol.
  5. hvyman

    Project Git 'er done!: Stages 1, 2, 3, 4....Stage 5- Reassembly after 13 years!!!

    Where did you get the bolt you put on the cps? Have you seen ballerbolts.com?
  6. hvyman

    driver side upper control arm bolt bent

    Ya the washer has to stay next to the control arm and then it comes right out.
  7. hvyman

    Wheel Fitment & Question Thread

    You will have to roll the fenders. And depending on how low stretched tire. 265 or 255 rear and prolly a 245 maybe even 235 for the front. Depends on how low tho.
  8. hvyman

    2j cams for a 1J

    If there already machined you just need shims to re shim so you have the correct clearance. Other than that everything else is the same.
  9. hvyman

    Standard timing belt, or high performance belt?

    My regular gates belt cost me 9$.
  10. hvyman

    mkiii 2jzgte heater core hoses?

    Could go to the parts store and look through there hoses.
  11. hvyman

    Fan shroud question

    You will have to either trim the blade or space it out tho. I just trimmed mine on a grinder. I'd suggest making a template and marking it tho so there the same. Will make it easier.
  12. hvyman

    Fan shroud question

    If stock bolts up use that. With a 2jzge clutch and blade you will have plenty of room.
  13. hvyman

    I screwed up...Need some help

    That screw is set from the factory. Its why 89+ have it blocked off. Is the timing set at 10?
  14. hvyman

    Wheel Fitment & Question Thread

    all depends on how far its flared. You get more room with coils overs as well. Could run 11 +25 or +20 easily with roll and little pull.
  15. hvyman

    7MGE Oil Shaft Bearings

    Factory toyota is fine. They only come in 1 size so they must be checked for clearance before use. IF the engine has good oil pressure i wouldnt be worrying about it.
  16. hvyman

    TPS Calibration

    here is the link jj posted. http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=101 You test it. If its out of spec you replace it and set it.
  17. hvyman

    TPS Calibration

    If it is out of spec needs to be replaced.
  18. hvyman

    Wheel Fitment & Question Thread

    It's all in the offset.
  19. hvyman

    Code 11 and idling problem

    Check to make sure the grounds on the intake manifold are good along with power to the Ecu.
  20. hvyman

    Oil pan and dipstick

    No its rear sump.
Top Bottom